Question about 1997 Ford Crown Victoria

1 Answer

HOT & COLD ELECTRIC VENTS NOT MOVING.

1997 CROWN VIC ELECTRIC AIR VENTS DONT WORK. HEAT COMES ON INSTEAD OF MAX A/C, COMPRESSOR RUNS & COOLS, BUT VENT IS BLOWING OUT HOT AIR.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Blend door actuator. When it fails for some reason it turns to the hot side and gets stuck. Dash must come out. I usually do it in 3 hours, because I've done it numerous times.

Posted on Jun 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHY DON`T I HAVE A\C comming out of my vents?


temp control mode door stuck in heat position.

Jul 30, 2014 | 2006 Ford Crown Victoria

1 Answer

A/c does not come out of vents on dash


the steps are easy
(bad loop, bad electrics)
ill stated step
ill assume the blower works and A./C lamp glows.
ill assume this is cold air failure as A/C in car are both.
ill assume it not hot air and that ambient air is blowing. not hot.

1: does the compressor shaft spin? fast, (belt must be present and tight)

if it spins this is a loop freon issue, (engine rpm 800 or more)
if it dont spin the AMP logic, see errors.
ask for help if compressor shaft dont spin
the shaft is not the pulley the pulley always spins running.

Jun 10, 2014 | 1996 Chevrolet S-10 Pickup

1 Answer

Dash vents blowing cool air instead of heat


You have problem in 1) Your air flow system have gone down and some plastic valves that opens to cold position or to hot position is broken. Solution: remove panel and check this plastic valves that controls airflow.
2) Your heat salon radiator is very poor and can't blow in all directions. Solution: replace salon heat radiator.
3) Your cooling system don't have good limit of coolant. Solution: fil it to min - max position.
4) Your cooling system isn't bleeding. Solution: make system without air in it.
Hope this will helps.

Oct 04, 2013 | 2001 Audi TT

1 Answer

Hot air comes out of defrost vent at top dash and cold air out of


Hey, what setting is your A/C on Max AC? AC? Cycling air in vehicle or taking it from outside

The car icon on the right in this image is what I'm referring to when I say cycling air in vehicle.

373a147.jpg
Also, do you ever have cold air blowing? on any setting or any speed? if not, find your A/C fan, it is smaller the the engine cooling fan, sometimes there are 2 fans together. The AC fan should be located at the front of the vehicle and is usually electrically powered.

Also try to find your compressor, looks something like this:
730c4b9.jpg

is it running? is one pipe hot and one cold? (the pipes I am referring to are inlet and outlet pipes of the A/C compressor unit.)

Hope this helps, keep me posted

May 10, 2009 | 1994 Mercedes-Benz E-Class

2 Answers

Vents don't open when I turn on max A/C


I had the same problem on my 2003 CV, took it to ford and found out it was the AC controller. The controller is the part you see on your dash, that allows you to switch between heat/ac etc.. Watch for the cost though, To have a new controller installed was approx $750

Apr 26, 2009 | 2003 Ford Crown Victoria

1 Answer

1995 Crown Vic. Heater blowing cold air


they radiator flush has created a blockage in the heater core that creates the heat. you dont want to replace this part because it can get $$$$. i would take it back to the shop and have them try the service again( at no charge) to see if it can remove the block

Jan 02, 2009 | 1997 Mercury Cougar XR7

1 Answer

1995 lincoln town car heater


the door opening & closing on Max a/c is the inside/outside air intake door.
The temp blend door is the one you are concernd about. It says you have to remove instrument panel for access. ouch!!!

-------------------------------------
A/C Electronic Door Actuator Motor
The A/C electronic door actuator motor (19E616) is located on top of the A/C evaporator core housing assembly.
  • Its function is to move the A/C air temperature control door on command from the control assembly.
  • The A/C electronic door actuator motor contains a reversible electric motor and a potentiometer. The potentiometer wiper is connected to the actuator output shaft and moves with the output shaft to indicate the position of the A/C air temperature control door.
  • Battery voltage is applied to the ends of the potentiometer. The voltage available at the wiper indicates the position of the potentiometer. The actuator wiper voltage is sent to the control module and matched with the wiper voltage of the module potentiometer. The printed circuit board then drives the actuator motor in the direction necessary to make the actuator wiper voltage agree with the control module wiper voltage.
71fc1ba.gif

Dec 27, 2008 | 1995 Lincoln Town Car

Not finding what you are looking for?
1997 Ford Crown Victoria Logo

854 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...