Question about 1996 Chevrolet C1500

1 Answer

96 c1500 2wd engine has started sounding like its

96 c1500 2wd 5spd. engine has started sounding like its stuck in high idle, it feels as if something is putting a drag on the engine, it shifts through all 5 gears, but at 2.2 rpms the enginge reves up and stays there until i left off the gas, then when i get up speed to shift into the next gear, my engine reaches that same spot where it sounds like its reved up and makes a noise like i have it floored. this has never happened before. what could be causing this? i put premimum gas in, i put Lucas fuel enjector cleaner in, I checked tranmission fluid, i have checked everything. could the clutch be the problem, maybe its not dis engaging or its hanging up, I can shift through all gears, its just the engine sounds like its stuck in high idle. i have 143,000 miles, I bought my truck in 97, it had 12,000 miles, i drove it from Arizona to Michigan, lived there for 10 years then drove my truck back home to Arizona, i just put new tires on her, all 4, she has been a good truck overall. This issue with the engine has never happened before, i really hope its not something serious, can someone please tell me what to do to fix this?
Thank you,
Donna Plotts

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

It sounds like you have a vaccum leak more than likely. check near the intake manifold near the fire wall there are several vaccum lines there. also remove the the breather hose and check that your throttle plate is not sticking(this of course only applies if you have fuel injection. if you have a tbi or it's carburated check the throttle linkage to see if it's perhaps sticking

Posted on May 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 jeep grand cherokee limited 5.2 V-8 seems high idle," like a plane ready for take off".


Not me! But I digress. It seems that the cold start heater is stuck or broken...check it out.

Jan 13, 2013 | 1996 Jeep Grand Cherokee

1 Answer

My 96 mitsubishi montero LS is having a a couple problems


the first problem is your idle air control vavle it is located on the thottle body . the idle air control vavles job is to have the engine run a little high to warm the engine ,and then shut off once engine warm. . the other is a your blend door is stuck open or close. you may have something stuck in it. the bend door motor is located in the heater box in the dash

Oct 31, 2012 | Mitsubishi Cars & Trucks

1 Answer

I have a 96 Chev. Beretta, and hard to start with sputtering and sneezing after misfire. and then will eventually start but very high idle speed.


If the check engine light is on I would check it for trouble codes first.
The high idle could be a vac leak or faulty idle air control valve.

Jul 27, 2012 | 1996 Chevrolet Beretta

1 Answer

96 S-10 Pickup when engine is started it sounds like it is running at full throttle?


it might be try the following...
1.) disconnect the IAC (idle air control motor) and start the vehicle

you might set a code and turn on the check engine light, but if the engine doesn't start and run at a high idle then you know you are on the right track

the computer could be commanding the high idle on start up for a few different reasons or the IAC could just need replacement

without a professional scan tool you will have to guess

however, the IAC should be less than $40 at any parts store

May 13, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

I have a 1987 f-150 ford and it high idles at 2500 to 3000 rpm what can cause this problem. this truck has a 5.0 in it.


Check the throttle cable for binding and the engine for vacuum leaks.
You may have a stuck idle air control solenoid.
It is hard to say what it might be. Start running some tests and it will help narrow your search.

Apr 21, 2010 | 1987 Ford F 150

2 Answers

My 96 Mustang GT engine will idle fine in park or


it sounds like either the torque converter solenoid is stuck or the torque converter itself is bad

Sep 10, 2009 | 1996 Ford Mustang

1 Answer

Engine Reving to high at idle 96 1.3


sounds like the intake gaskit to me....but i could be wrong i'm not big on mazda

Mar 03, 2009 | Mazda MAZDA3 Cars & Trucks

Not finding what you are looking for?
1996 Chevrolet C1500 Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...