I can not find a way to remove the speakers from the dashboard and would like to know the recommended way to do so
SOURCE: Rear Speakers
it not necaserry to remove rear speakers just change setting of ur music system only use a front speaker
SOURCE: Replacing speakers in Mitsubishi Galant
If the car is an 03 galant it is very simple to remove.
DRIVER SIDE:
Remove the window crank if it is not Electric Window.
Remove the Screw that holds the "Open Door Handle" cover.
Remove the Screw that holds the "Pull Handle Pocket"
Remove both plastic covers.
Remove all 3 hidden crews that have a plastic cover over them.
One is toward the front of the door top and the other two are toward the rear of the door top and bottom side.
Carefully pry around the door trim panel to disengage it from th retaining clips, along the sides and bottom. If you have electric windows, disconnect the if from the door trim to access the speaker. Same procedure for both doors.
SOURCE: Front door speakers
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: how do remove the dashboard
1st disconnect the battery then a long journey awaits you ...disconnect all the bottom dash panel screws and all the screws underside the dash you ll need to gain access from under it to unscrew the bolts that hold the dash in place remove trim panels on both sides of the window frame as well the glove-box unscrew that as well pull the ash tray if necessary the rest should be very well self explanatory from there and reinstall is reverse procedure
SOURCE: i want to upgrade the speakers by the back window
No u have to remove the back seat. Bottom first then top. There's two clips under the seat u pull them and the bottom comes off. Then there's 4 bolts holding the seat in. Now the carpets tricky because its under the plastic side panels and around the back light. I ended up cutting around d the side
Remove the screws holding the dash speaker grilles in place, with the appropriate right angle screwdriver.
Remove the screws holding the speaker in place, again with the appropriate right angle screwdriver.
Lift the speakers from the dash. Disconnect the harness securing the wire to the factory speakers.
Connect the aftermarket speakers to the speaker harness adapter's flying leads. Connect the adapter end to the factory harness plug, sticking out out of the dash.
Set the aftermarket speakers back into the factory holes, and secure them with the original screws. Replace the grille covers, and secure them with the original screws.
THANK YOU
I have a diagram that shows where each screw that holds dash are located. I need and email or fax to get it to you.
114 views
Usually answered in minutes!
×