Question about 1992 Oldsmobile Bravada

1 Answer

4.3 NEEDS TO BE REPLACED -- HAS BALANCE SHAFT -- CAN IT BE REPLACED BY ONE THAT DOESN'T HAVE THE BALANCE SHAFT

I HAVE A 1992 BRAVADA WITH A 4.3 IN IT. I'VE DISCOVERED THAT IT HAS A BALANCE SHAFT IN IT. IS IT POSSIBLE TO REPLACE THAT ENGINE (NEEDS TO BE DONE) WITH ONE THAT DOESN'T HAVE THE BALANCE SHAFT?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 102 Answers

You should be able to, a 4.3 is a 4.3, chevy motor, bellhousing and mounts are all the same, just might need to do some parts swapping from old engine (intake and electical parts)

Posted on May 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

AWD light is on 1999 Oldsmobile Bravada. before it came on it would pop or clunk when backing up while wheel were turned.


Check driveline for loose or worn u-joints drive shaft slip joints and cv joints at the front axle.

Feb 04, 2013 | 1992 Oldsmobile Bravada

1 Answer

97 Olds Bravada My brake & hazard lights don't


There are TSB's for this issue. I chased this issue for months on mine. Go find the TSB's, there's troubleshooting pointing out the faulty part. It could be, the brake light switch, the hazzard light switch itself, the multi-function switch. I had replaced all of these and still had the problem. Wiring that goes from the brake switch to up near the fender was shorting against the fender. I replaced the pigtail, problem fixed. Best bet to help you, is find the TSB's for this problem.

Jun 28, 2017 | 1997 Oldsmobile Bravada

1 Answer

Working on Honda Prelude 1992 with a 2.2 motor can't get bolt off crankshaft pulley wanting to know if it is left or right handed threads


It is standard thread (right handed) and a little more information if you need it: there is a hole on the rear of the block on the drivers side located just behind the rear balance shaft so you can lock your engine #1 cylinder @ TDC with a 6mmX100mm bolt or screwdriver. there is a hole machined into the balance shaft that holds everything still so you can get done....I would also recommend the use of an impact....IT IS TIGHT!!!

Mar 11, 2011 | 1992 Honda Prelude

1 Answer

1992 egale talon turns over slow the starter is


How was the starting BEFORE all this work was done. Why was the timing belt replaced.

Dec 31, 2009 | 1992 Eagle Talon

1 Answer

02 olds bravada locked in awd


This is very common. It is the transfer case encoder motor. That controls the shifting of the transfer case. It needs to be replaced. Its not that hard to replace but the part is expensive. You will also need to replace the front drive shaft boot clamps, you have to cut the originals off when removing the front drive shaft. I've replaced many of these for myself and others. Good luck I hope this helps you.

Aug 14, 2009 | 2004 Oldsmobile Bravada

1 Answer

1992 Volvo 740 Wagon w/o Turbo: Timing Belt Needs Replaced


It is a right hand thread and you usually need an impact gun. Take the fan out of the way, to give you more room, I have found that helps.

Mar 30, 2009 | 1992 Volvo 740

4 Answers

1992 jeep cherokee sport, starting problems


is it diesel engine?if so chech ur heater plugs

Mar 27, 2009 | 1992 Jeep Cherokee Sport

1 Answer

1999 Olsmobile Bravada Vibration


It possible that the drive shaft need to be turn 1/2 turn and re installed, or the balance weight is missing from the drive shaft.

Nov 21, 2008 | 1999 Oldsmobile Bravada

Not finding what you are looking for?
1992 Oldsmobile Bravada Logo

Related Topics:

218 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...