Question about 1993 Geo Prizm

1 Answer

Front end shakes when i try to take off

I have a 1995 geo prizm and i put a new clutch in it now when i put it in first and go to take off the whole front end shakes

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

You need to have your flywheel lathed or replaced, or you need new tie rods thats what i had a problem with

Posted on Jun 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ignition key lock on my 95 geo prism is very loose inside so I cannot put it in accounting mode to pull cylinder out. What should I do?


it needs a new total lock assumbly,
or a new cylinder, the secret pin on the rear unlocks cyl.
and assembly muost be pulled reach it. (antitheft rules)
id remove the whole thing, and take it to any lock smith.
and they can fix it.
they re-key it,
some look at it and say, its END OF LIFE,
i cant see, can you put it in brighter lights?(sarc)
looking for magic silver bullets. sure... but there are non in this physically world of tumbler locks, 100s of years old in design.

Oct 01, 2016 | 1995 Geo Prizm

2 Answers

I just put a clutch in my 96 Geo Prizm with pleasure plate and throwout bearing now I can't get it into reverse,first gear is hard to get and 5th gear will not engage could this be a linkage problem?


its a hydra. clutch. acutator
so did you check that first. and bleed it?
no air allowed. there.
did you prove the clutch MC and slave were good
first before replacing the whole main clutch>?
before the job started was the MC dry?
clutch master cylinder, MC.
the bleed in on the rear of the SLAVE>



26289833-3ub3qkuug2p3y0mj4fqyuh53-3-0.jpg

Sep 23, 2016 | 1996 Geo Prizm

1 Answer

I have 1995 geo prizm I put new fuel pump in it started ran good for two and now want start what you think it is now


why did you put in the pump.
we need the reason for that first.
for two what ?(days, weeks , years?)

Apr 21, 2015 | 1995 Geo Prizm

2 Answers

How can i fix a tie rod on my 1995 geo prizm


Go to your favorite local auto parts store and buy one after you figure out what parts are bad. Jack up the front of the car, put it on jack stands and take off the front wheels. both tie rods will be exposed. You can visually inspect them for being straight and not loose on either end.

Dec 11, 2012 | 1995 Geo Prizm

1 Answer

Where is the fuel pressure regulator located on a 1995 geo prizm


The fuel pressure regulator. its on the end of the fuel rail. pull the vacuum hose off the regulator and look inside. If the inside of the hose is wet with fuel, the regulator is bad.

Nov 11, 2010 | 1995 Geo Prizm

1 Answer

My 1995 geo prizm idles roughly in park and the engine dies when you put it in gear. it doesn't matter if the engine is cold or hot and forget trying to use the a/c. everything works fine while moving at...


The problem is in the idle air control valve which controls the idle of the motor and idles the motor up when an extra load is put on the motor. It is mounted on the throttle body and is a little round barrel looking item with a plug in on the end of it. change this part out and clear the engine code in the computer and it should fix the issue.

Sep 21, 2009 | 1995 Geo Prizm

2 Answers

1995 geo prizm gas tank replacement


what is the unit called on top of gas tank where both fuel lines come into the fuel pump?

Oct 06, 2008 | 1995 Geo Prizm

Not finding what you are looking for?
1993 Geo Prizm Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...