Question about 2004 Chrysler PT Cruiser

1 Answer

How to install fan assembly for pt cruiser

How do you dissasemble the car to get to fan

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

It actually isn't as hard as it looks. First remove the battery and air box. Then remove the grill and upper radiator support. Remove the upper radiator hose from the radiator. Unbolt the fan assembly and pull gently forward on the radiator to remove the fan.

Posted on May 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car not start


Hi;
The Ligths turns on? is the Battery ok? Honks the Horn?
How long is the car unused?
Can you test the battery charge?How many Volts of current (DC Volts)have?
Did you check the Fuses?sometimes the fuse is blown(There is a Fuse for starter and ignition)See fuses box and check.
If all is ok, check under the car the starter cables.
Other tip the battery clamps are rusted,dissasembly,wash with current water,use some sand paper to clean ans assembly again.

Jun 02, 2014 | 2001 Chrysler PT Cruiser

1 Answer

Engine light came on and car is over heating. Took it to auto zone and was told it's the fan relay. Its a 2003 PT Cruiser, Turbo. I opened the fuse box under hood. There are 3 spots for relays in there...


Turbo Radiator Fan

The radiator cooling fan is a variable speed electric motor driven fan. The radiator fan assembly includes an electric motor, fan blade, and a support shroud that is attached to the radiator. The radiator fan is serviced as an assembly (fan motor/fan/shroud).

The variable speed radiator fan is controlled by the Powertrain Control Module (PCM) by way of a Pulse Width Modulated (PWM) signal. The duty cycle ranges from 30% for low speed operation then ramps-up to 100% for high-speed operation. This fan control system provides infinitely variable fan speeds, allowing for improved fan noise, A/C performance, better engine cooling, and additional vehicle power.

To control radiator fan operation, the PCM looks at inputs from:

Engine coolant temperature
A/C pressure transducer
Ambient temperature
Vehicle speed
Transmission oil temperature (automatic transmission only

HENCE CHECK THE PCM

Jun 26, 2011 | 2003 Chrysler PT Cruiser

2 Answers

My electric cooling fan went out will a neon of the same year work ?


Needs to be same make of car, year, and engine size, to work.

Aug 31, 2010 | 2001 Chrysler PT Cruiser

1 Answer

How do i remove radiator fan from my 2004 pt cruiser?


Hope this helps!

Removal & Installation
NOTE The fan motor, fan, and the shroud are serviced as an assembly.



CAUTION Do not open the radiator draincock with the system hot and under pressure, because serious burns from coolant can occur.


  1. Disconnect negative cable from battery.
  2. Remove battery and battery tray.
  3. Drain cooling system below upper radiator hose level.
  4. Remove grille.
  5. Remove upper radiator closure panel and center brace.
  6. Disconnect upper radiator hose from radiator.
  7. For turbocharger equipped vehicles: Remove radiator inlet neck.
  8. Hoist vehicle.
  9. Disconnect radiator fan electrical connector (.
  10. Remove the two lower and left side radiator fan screws and.
  11. Lower vehicle and remove the remaining radiator fan attaching screws.

    WARNING Care should be taken not to damage the radiator cooling fins and tubes during fan removal.

  12. Remove radiator fan by lifting up from the engine compartment.

c83d6ac.gif
Radiator fan mounting points

To install:
  1. Install the radiator fan into position on the radiator.
  2. Hand-start all radiator fan fasteners.
  3. Tighten all radiator fan retaining screws to 55 inch lbs. (6 Nm).
  4. Connect the radiator fan electrical connector.
  5. Carefully lower the vehicle.
  6. For turbocharger equipped vehicles: Inspect radiator inlet neck O-ring. Replace if necessary. Install radiator inlet neck. Torque fasteners to 55 inch lbs. (6 Nm).
  7. Connect the upper radiator hose to radiator. Align hose and position clamp so it will not interfere with the engine or the hood.
  8. Install upper radiator closure panel and center brace.
  9. Install grille.
  10. Install battery tray and battery.
  11. Connect cables to battery.
  12. Fill cooling system.

Apr 18, 2010 | 2004 Chrysler PT Cruiser

2 Answers

2001 PT Cruiser , have replaced the fan motor twice , a/c fine 2 weeks then blows it again ,something electrical I know ,but what ?


Check the voltage output of your car with the engine running. It should read 13 to 14 volts. only. Higher than this will cause damage to the fan motor, and other 12v gadgets in your car. Is this happening? If not, then, check the aircon evaporator for grounded wiring connections. This is the line from the fuse box terminal to the line going to the aircon. Grounded line can cause a lower voltage reaching your fan motor, forcing it to run undervoltage, overheating it. Send us your e-mail so we can give you further
assistance.

Oct 02, 2009 | 2004 Chrysler PT Cruiser

2 Answers

Its constantly running hot


have you tryed the thormostat or flushing the radiator

Jul 08, 2009 | 2001 Chrysler PT Cruiser

1 Answer

Told I need to replace fan assembly


If the fan is coming on, you don't need a new fan. Is the A/C compressor cycling off and on with the fan? If the compressor is running fine, and the fan is the only thing cycling, I would suspect a relay first.

Jun 02, 2009 | 2004 Chrysler PT Cruiser

1 Answer

AC will not on engine fan


fan relay bad...fan motor assembly bad or bad ac pressure switch

Aug 03, 2008 | 2003 Chrysler PT Cruiser

Not finding what you are looking for?
2004 Chrysler PT Cruiser Logo

Related Topics:

707 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...