Question about 2002 Nissan Quest

1 Answer

Van will not accelerate on takeoff

2002 nissan quest will not take off from a stop or up hill without putting the pedal to the floor and then it goes fine.( its only idiling at 500 rpm)

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

NEEDS A THROTTLE POSITION SENSOR MOST LIKELY, THAT HAD SOME PROBLEMS WITH THEM NOT SENDING SIGNAL UNTIL FULL THROTTLE.

Posted on May 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How To Check & Reset Your 2002-2006 Nissan Altima Service Engine Soon (SES)...


The following directions will help you decode your 2002-2006 Nissan Altima's Service Engine Soon (SES) light and reset it.<br /> <br /> <span style="font-weight: bold;">Obtain The Trouble Code</span><br /> <ol> <li>Turn the ignition key to the ON position and wait three seconds.</li> <li>Put the accelerator pedal to the floor and release it five times in less than five seconds.</li> <li>Wait exactly seven seconds. Put the accelerator pedal to the floor for ten seconds until the SES light flashes.</li> <li>Release the accelerator pedal and start counting flashes to obtain the four-digit trouble code.<br /></li></ol> <ul> <li>Long flashes (0.6 seconds) indicate the first digit of the code; count the blinks one through nine and write down the first digit. (Ten blinks indicates a zero.) </li> <li> The next three digits blink faster (0.3 second) and have a 1 second pause between digits.</li> <li>The ECM code repeats until you turn the ignition key to the OFF position.</li> <li>You can look up the trouble codes in the Service Manual.</li> <li>If you get four blinks of ten, or 0000, the ECM indicates no malfunction.<br /></li></ul> <br style="font-weight: bold;" /><span style="font-weight: bold;">Clear The Trouble Code</span><br /> <ol> <li> Clear the code and the SES light by holding the accelerator pedal down to the floor for 10 seconds or more while the SES light is blinking.</li> <li>When the pedal is released, the ECM will erase the trouble code(s).</li></ol>

on Feb 15, 2011 | 2002 Nissan Altima

1 Answer

Accelerator pedal position sensors 2002 f450


clean electrical connections on the pedal end accelerator on top to the engine

May 27, 2013 | Ford Cars & Trucks

1 Answer

My 1997 Nissan Quest Van when I start it it's okay, but when I accelerate the gas it starts to sputter. These miniture backfires go on but when I release the gas pedal the sputtering stops. I am n


the first thing I would start with is looking for vaccume leaks. be sure to check your EGR valve, then move to your MAP sensor. The next thing that it could be is a stopped up catylic converter

Apr 29, 2012 | Nissan Quest Cars & Trucks

1 Answer

1995 nissan quest GXE: Power seat belts stopped working.


the passive restraints control module is behind the panel by the gas pedal.

The fuse is a 30 amp fuse taht also controls power window. in battery box under hood in front of battery. chart on cover.
then it goes through left hand circuit breaker which is behind leftkick panel above fuse panel I think. there are 2 circuit breakers next to each other.

May 22, 2009 | 1995 Nissan Quest

1 Answer

2002 Nissan Quest speedometer - not working


Its most likely related. Vehicle speed sensor is bad

May 06, 2009 | 2002 Nissan Quest

2 Answers

2004 nissan quest idles rough when van is stopped


Have 2004 Nissan Quest. After 40 mph Van runs rough and there is a loud rattleing noise that sounds like an old 4 bbl carb waaaah, but ther is no code

Aug 14, 2008 | 2004 Nissan Quest

Not finding what you are looking for?
2002 Nissan Quest Logo

Related Topics:

312 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...