Question about 1998 Chevrolet Blazer

1 Answer

Fuse marked ENG1 in fuse box under hood keeps blowing out when I replace it. I don't know what this fuse is for or what it powers it is 10amp so it can't be for anything heavy. The only thing not working is my tack. Can you tell me what this fuse is for?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,623 Answers

Hello gorick...the ENG1 fuse is ignition related on the S10. Look at the labeling on the fuse panel and make sure you have the correct fuse installed. I was thinking it called for a 20 amp fuse. If so replace it. If it blows again you have a short in the circuit.
A good place to check is where the bracket for the upper radiator hose and the engine harness come near each other. Inspect this area carefully, i have found the wireing harness shorted here when it rubs a hole in the wires and grounds out.
Good luck...i hope this helps

Posted on May 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 Buick century custom and I had drained my reservoir. Now everything I attempt to start my car my pcm fuse blows instantly. I've replaced my ignition switch and fixed my ignition column yet...


pcm fuse blows instantly ???? What number fuse , how many amps ? Where is it located ? under hood fuse box . ECM fuse 10amp ,underhood fuse box ???? When does the fuse blow ? when you turn the key to the start position . How about when you turn it to just on position ? Replacing the ignition switch an the column ????? Why did you replace these ? You think it was going to fix the problem ? or someother problem ? Bad computer maybe .

Sep 16, 2017 | Buick Cars & Trucks

1 Answer

Fuse for 2002 yukon dash board


There are a four fuse's that supply B+ voltage to the instrument cluster . Three are in the left instrument panel fuse box and one is in the under hood fuse box .ING 1 fuse 10amp , ING 0 fuse 10amp and CRUISE fuse 10amp . these fuse's are in the I/P fuse box. The last one is RADIO fuse 15amp located in the under hood fuse box . What kind of problem are you having ? A gauge not working or the whole instrument cluster not working ?

Jan 01, 2017 | Cars & Trucks

1 Answer

Where is the fuse for the gauges on a 2004 chevy burban?


The IPC/DIC fuse 10amp located in the under hood fuse box . Also check SEO B1 fuse 15amp in same fuse box . Plus IGN E fuse 10amp. an SEO IGN. fuse 10amp All in same fuse box ! If you find the fuse are all good the stepper motors inside the instrument cluster that control the gauges are bad an need to be replaced ! How to repair GM Instrument Cluster Speedometer Gauge Stepper

Sep 22, 2016 | Chevrolet Cars & Trucks

1 Answer

2008 Grand Prix GXP keeps blowing the 10amp fuse for the AC. When replaced, it runs cold again until I start driving, then it blows and only has hot air once again. Very frustrating in Texas heat!


13
A/C CLUTCH Fuse
10A
A/C COMP Relay - try replacing the A/C compressor clutch relay # 38 in under hood fuse / relay box . ! Could be shorting out after hot . I don't won't to get to technical on you, doing voltage drop testing on the circuit . If not relay the compressor clutch coil could be going bad when heating up . There are videos on you tube , testing A/C compressor clutch relay .

Jul 05, 2016 | 2008 Pontiac Grand Prix

1 Answer

Diagram of a 2000 chevy express wiring of a starter


( one question i have is every time the ignition fuse blows do i need to replace the starter relay? ) NO ! You have a dead short to ground on one of the circuits that fuse feeds. Do you know how to find a short circuit ? Video's on youtube show how. The fuse that blows ,is it IGN - A 40 amp. located in the under hood fuse/ relay center ? That fuse feeds B+ voltage to the ignition switch ,which powers up other thing's ,fuse's etc.. Not just the starter relay ! I see five other fuse's that get power from that fuse when ignition switch is in the start or run position . In the I/P fuse panel the gauges fuse #4 10amp , air bag fuse #10 10amp , turn b/u fuse #16 20amp. , Plus trans fuse #20 10 amp ! Pull out these fuse an try to start the van. if the ignition fuse doesn't blow the problem is in one of these other fuse circuits. There is one more fuse that get's B+ power from the ignition switch and ign A fuse ,crank fuse fuse #8 10amp. this powers the control side of the starter relay .
You can find a free wiring diagram here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine . Under system click engine , under subsystem click starting. Click the search button then the blue link.
If you pull those fuse's i mention and it still blows the fuse look for a shorted ignition switch or wiring from ignition to the starter relay , not the relay itself. Park neutral safety switch . Isolate the circuit , pull the relay out of it's socket ,pull the crank fuse #8 in the I/P fuse box. with a ohm meter check to see if that part of the circuit is shorted to ground. Do you know how to do that ? Do you have a volt ohm meter ? You can buy one cheap at parts store .

Sep 14, 2017 | 2000 Chevrolet Express Cargo

1 Answer

2002 pt cruiser fuse #11 blown


According to my diagram, number 11 is a 10amp fuse that powers the ac clutch relay. I don't see how it would keep the engine from starting.
Is the fuse you are talking about in the engine compartment box and is it a 10amp ?

Aug 06, 2012 | 2003 Chrysler PT Cruiser

2 Answers

I need a diagram for the under hood fuse box. More importantly the specific 20 amp fuse labeled F21. What is it for. I have a 1998 jeep wrangler 4.0 4wd.


Are you sure that this is for 20AMP, according with the repair manual, the position 20 in the Power Distribution Center if for Power Motor ABS Pump, and is 10AMP.

Verify it..

Mar 17, 2010 | 1998 Jeep Wrangler

1 Answer

I have a 2001 chrysler town and country with an am/fm cassette deck and 4 disc cd changer. my problem is the radio quit working while adjusting the volume and now will not work at all checked the relays...


Check the power (fuse) distribution box under the hood. All the way up top towards the windshield there should be a small 10amp fuse marked "mem" see if that fuse is good and try it again.

Feb 25, 2010 | 2002 Chrysler Town & Country

1 Answer

WILL NOT CRANK


try replacing the eng1 fuse 15amp under the hood in the black fuse box. I had the same problem and this fixed my problem.

May 26, 2009 | 2000 Chevrolet Blazer

2 Answers

Honda Civic year 1999


It would be fuse 27 in the underdash fuse box, 10amp

Feb 10, 2009 | 1984 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

664 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...