SOURCE: 1999 Chrsler Sebring LXi v6 2.5L. Car dies.
I had the same problem with my 1999 Chrysler Sebring 2.5L V6 Convertable. It started stalling at intersections; would lose RPMs' and die while driving it; and would not start unless it sat for a few minutes. Once it started, you'd have the scenario start all over again...
I hadn't kept up my maintenance schedule like I usually do, so I did the usual; I replaced my spark plugs and wires, changed the oil and filters, ect...
Finally, after it doing the same thing and wasting a ton of time and frustration on the side of the road, I took it to a mechanic that put it on his $9,000 diagnostic machine. The verdict; CRANK SHAFT POSITION SENSOR!
The Haynes Manual will tell you wrong on its location for the 1999 Lxi 2.5L V6 convertable; it is NOT LOCATED BEHIND THE BATTERY TRAY. The crankshaft position sensor is actually located about 4 to 6 inches below the distributor, which is about dead center of the motor, on the transaxle housing.
You do have to take off the tire and the skirt cover to get to it. I had to purchase two long socket extensions just to get to the bolt that mounts the sensor to the transaxle housing; but it was well worth the 20 bucks...
All in all, it took me three hours to find the damn thing, and then to figure out what I needed to take the old one off and get the new one installed.
The $65 dollars that I spent to find out what the problem was is worth it....
Now, the car runs better than ever....
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
SOURCE: 2000 beetle cold start rough idle until it warms
Could be the fast idle sensor check to see that the vacume line is hooked up properly.
SOURCE: 2004 chrysler sebring idle speed is too slow. HOw
why do you want your rpms higher while idling? you don't want them high because your gas bill will reflect that. slow shouldn't matter but if it's dying while on idle it could either be your mass air flow sensor or your fuel filter being clogged
163 views
Usually answered in minutes!
How long should it take for it to go off fast idle,if I try to drive it before it goes off of fast idle it stumbles on take off from a stop
×