At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: How do you remove the interior panel on a 1992 Jeep...
If there arent any screws visible then its probably snapped in place all you have to do is pull firmly on the outer most edge and it should release you may need to use a flat head screwdriver.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Make sure you unlock the locks then try pressing down and holding in the plastic that surrounds the tail gate handle while pulling on the handle at the same time. The hatch should open. I've seen this same problem on a few Cherokees.
They are not related ...
The lift gate locking mechanism can be accessed by removing the interir trim pannel on the gate ... and locating the locking actuator and replacing it...
The same can be done for the power window motor ... remove the interior trim panel and replace the power window motor...
You will need to remove the interior panle from the loft gate to axess the latch
there is 4 screws along the bottom of the panle to remove then carfuly pull the panle away from the lift gate there is plastic clips that hold the panle to the gate these may need to be replaced when re installing the panle they can be purchased at the jeep dealer.
now look into the lift gate and you will see where the handle rod conects to the latch lift on this rod and the gate will open
to replace the handle remove the 2 10 mm bolts and disconect the rod from the latch install the new handle and rod to the latch install the 2 10 mm bolts. install the panle and 4 screws
this should cover it
Does it make a horrible noise when you try to unlock it? If it does then you have to remove the interior paneling on the lift gate and replace the "actuator" i found one at a junk yard for about $40 and once you get the paneling off it only takes one screw and the connector. really simple and cheep. Hope this helps.
you have to get in behind tailgate interior trim and pull handle lever as this has come off from the actuator,once tailgate is opened remove panel and relocate actuator bar and you might want to cable tie bar in place for the future
I have a 2001 Sienna and have had to replace most of my tail light bulbs.
The bulbs that are mounted in the fender (wrap arounds) have acess panels in the van's interior that easily pop out and expose the back of the light assembly.
However, the bulbs that are found in the lift gate are a different matter. You have to remove the whole interior panel to the lift gate to expose the light assemblies. Go to your auto parts store and get a tool to help pop out the plastic retainers from the lift gates metal frame. Don't force the retainers out. Go slowly and gently so that you don't damage the interior panel. If you are really gentle you might even get to reuse the retainers.
Hello
The sensor your looking for is on the latch for the lift gate
you will need to remove the lift gate panel to access this it has a single wire switch
RD
×