Question about 1993 Cadillac Fleetwood

Open Question

1993 fleetwood brougham wont start

I have a 1993 fleetwood brougham that was running fine. It sat for about 4 days when I went to start it it would not turn over at all. The starter was checked and is good and I bought a new battery. All the lights and radio come on, but it will not make any noise like it is even trying to turn over when I turn the key...any suggestions or advice would be greatly appreciated..Thanks

Posted by on

  • s_penley May 15, 2009

    Hey Tednj? I know the fuses are good, but how do you check the relay? Also when I turn the key all the lights stay on except the speedometer light it goes off.......until I turn the key back then they come back on......

  • Teddi B May 11, 2010

    It sounds like the starter is not getting power, check the fuses and relays in the engine compartment.



6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 132 Answers

SOURCE: body control module

In the trunk

Posted on Jan 31, 2009

  • 20 Answers

SOURCE: 1983 cadillac fleetwood brougham 4.1 liter battery not charging

check the alternator fuse that can be a fuse link by the battery pole,check alternator voltage on the alternator red wire or connector,it should the same as on the battery ,check ground wires for loose intermitent contact

Posted on Aug 16, 2009

  • 142 Answers

SOURCE: replacing

Yes it is behind the glove box there are 2 behind the glove box the one you see first is the brake controller. you have to take that one out first to get to the ECM. yes it is about the size of a radio.

Posted on Oct 09, 2009

  • 173 Answers

SOURCE: i have a 1993 cadillac fleetwood brougham and i

pull out one fuse at a time. replace all blown fuses. this will take a few minuts longer but u may find a few blown fuses that will fix your problem

Posted on Apr 03, 2010

  • 6826 Answers

SOURCE: 1993 cadillac brougham fleetwood. how do you


  1. Disconnect the wiring harness from the Crankshaft Position (CKP) sensor.
  2. Remove the fastening bolt for the CKP sensor.
  3. Remove the CKP sensor and the O-ring seal from the engine block. To install:
  4. Thoroughly clean the mating surfaces of the CKP sensor and the engine bock.
  5. Install the CKP sensor with a new O-ring seal, into the engine block.
  6. Install he fastening bolt for the CKP sensor
  7. Attach the wiring harness to the CKP sensor. Be sure to route the cable correctly Fig. 1: The location of the Crankshaft Position Sensor (CKP) - 3.0L engine 91044g04.gif
    Fig. 2: Location of the CKP sensor connector - 3.0L engine 91044g05.gif
prev.gif next.gif

Posted on Nov 05, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Symptoms of a bad map sensor on 93 cadillac fleetwood brougham

Well code 23 is a faulty signal from the manifold air temp sensor. The sensor is telling the computer the air temp in the intake is out of range compared to the other readings.
Code 26 is a quad driver problem inside the computer.
Code 34 is a MAP sensor signal saying the vacuum is high when it should be low compared to the other sensors.
They may be connected or separate issues. You could check the MAP with a vac gauge.
I would clear the codes and see which ones come back again.

Jul 21, 2012 | 1993 Cadillac DeVille

1 Answer

My fuse panel diagram is missing from my 1993 cadillac fleetwood brougham and my digital dash isnt indicator lights are working so im wondering which fuse to check

i have a 1995 fleetwood brougham and when you open the doors inside lights dont work neather does any of the in side light work with doors closed even the ones on the mirror

Nov 03, 2011 | 1993 Cadillac Fleetwood

1 Answer

All my lights in my 1993 fleetwood brougham turn on, but when I try to start it, it don't start or crank.

Is the security light lit up on the dash when it wont start? If so, you have a VATS security issue. The system will actually turn off the starter if it feels that it is being stolen. It thinks its being stolen when the chip in the key doesnt communicate with ignition/lock cyclinder. Or if the security computer is going out. (it's called the TDM) If that light is on, its a dead give away that the vats is messed up. If no light, id try a good charge on the battery. Sometimes the lights will work fine but you dont have those cranking amps that you need to start.

Apr 15, 2011 | 1993 Cadillac Fleetwood

1 Answer

How do i reset the oil light on my 95 fleetwood cad

Oil Life Indicator
1. Oil life indicator will display CHANGE OIL when oil change is needed, based upon engine oil temperatures and driving patterns. After changing oil, reset
oil life indicator.
2. To reset, turn ignition switch to ON position. Do not start engine. Fully press and release accelerator pedal 3 times within 5 seconds. If CHANGE OIL light
comes on and stays on for 5 seconds, it did not reset. Reset system again.

Jun 08, 2010 | 1995 Cadillac Fleetwood

2 Answers

Firing order for 1989 cadillac fleetwood

For the 1989 Cadillac Fleetwood:
I do not know if you have the Fleetwood Brougham with the 5.0L V8, or the Fleetwood FWD (Front Wheel Drive) with the 4.5L V8; however I have included both below.

For the Fleetwood Brougham 5.0L V8:
Firing Order:

For the Fleetwood FWD (Front Wheel Drive) 4.5L V8
Firing Order:

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at!

May 19, 2010 | 1989 Cadillac Fleetwood

1 Answer

I was recently told that the 1993 cadillac fleetwood brougham's engine fails after around 100000 miles? Is there any history of this?

Maintenance is they key for long term performance..Anything mechcanical will wear prematurely if not maintanede

Apr 03, 2010 | 1993 Cadillac Fleetwood

1 Answer

I have a 1993 cadillac fleetwood brougham and i dont have the cover to the fuse box and my heater dose not work

pull out one fuse at a time. replace all blown fuses. this will take a few minuts longer but u may find a few blown fuses that will fix your problem

Jan 22, 2010 | 1993 Cadillac Fleetwood

Not finding what you are looking for?
1993 Cadillac Fleetwood Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides