Question about 1999 Daewoo Lanos

1 Answer

Cannot remove steering wheel

I have a 1999 Daewoo Lanos and my mechanic cannot remove the steering wheel. The nut holding the wheel on has been removed yet the steering wheel will not budge. A great amount of force was used as was a pulley from GM. Help!!! I want to install a sports steering wheel.

Posted by on

  • drf1976 May 15, 2009

    I thought there might of been one but cannot for the life of me find it. Was close to hacksawing steering wheel off.... bit extreme I know but am at wits end........

  • drf1976 May 15, 2009

    thank you. i will attempt this tomorrow. it's pitch black outside otherwise i would be out there now!! one last question, the mechanics at GM were the one with the pulley, do i require one for getting this bloody wheel off??? u have been very informative :)

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 40 Answers

There wouldn't happen to be a cir clip on the steering shaft or perhaps a half moon locking key? Just a thought

Posted on May 15, 2009

  • tiptoe846 May 15, 2009

    Just read this with google - you need to remove the steering wheel and the wheel lock collar then
    remove the signal switch plate.....on the left side of the steering
    shaft there is a single screw remove it and the ignition switch will
    slide out


  • tiptoe846 May 15, 2009

    first remove steering wheel cowling. 3 screws underneath, and 1 either
    side of the steering wheel.(turn the wheel both left, and right to get
    these, they will prob have plastic caps covering the heads)

    then remove the speedo surround, 1 screw at the top centre (above the
    milage reset pin) and a screw either side of the steering wheel.



    then screw either side of the speedo body, and thats it.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I take off steering wheel on my 1999 nissan pathfinder


A steering wheel is not an easy job. First remove the battery earth cable.

Be very careful that you don't activate the airbag while you're working. Remove the screws that hold the center pad to the steering wheel from the back of the steering wheel. Slowly move the airbag out and undo the wires.

Now the steering wheel shaft should be exposed with the nut that holds the wheel in place. Loosen the nut but do not remove it completely, leave it on the shaft.

This is the difficult bit. Grab hold of the steering wheel and pull real hard on it until it moves up against the nut. It might feel as if you are going to break the wheel, but it is not easy to do. Just keep at it until it comes loose. Now remove the nut completely and pull the steering wheel out.

Feb 25, 2015 | 1999 Nissan Pathfinder

1 Answer

How do you remove a steering wheel from a Daewoo lanos 2002 model


you need to remove the screws in the back of the steering wheel that hold in the air bag then unplug the air bag. behind it you will find one center bolt loosen that and your steering wheel is out.

Feb 06, 2011 | Daewoo Lanos Cars & Trucks

1 Answer

Hi i need to change a outer tie rod .how difficult is this?


disconnect from steering knuckle after loosening the jam nut on the inner tie rod.count the turns to remove outer end then screw new end on using the same amount of turns

May 13, 2010 | 2001 Daewoo Lanos

1 Answer

Im trying to remove crankshaft pulley am isuposed


the pulley nut comes off by turning it to the left yes counter clockwise and all you need is a steering wheel puller in most cases the pulley comes out by prying on it on one side with hand and tapping the opposite side with brass hammer.

Jan 10, 2010 | 2000 Daewoo Lanos

1 Answer

Seat and steering adjustment on the daewoo lanos


check uder or to the sides to move the seat and to adjust the steering wheel there should be a small leaver at the left side of the steering wheel

Jun 04, 2009 | 1999 Daewoo Lanos

1 Answer

Power steering


http://www.automotix.net/partshotline-daewoo-lanos-suspensiondrive-requests.html

there is a site that sells them.
hope that helped

May 29, 2009 | 1999 Daewoo Lanos

1 Answer

Severe bearing noise from front wheel bearing/cv joint area.Cv joint still lubricated,I tend to think axle support bearing is dry & on the way out,but only assuming.How does front wheel bearing come out of...


you have to replace bearing and hub as a unit.you have to remove remove brakes and caliper rotor set them aside dont disconnect brake line. get a piece of clothes rack wire to hold brake caliper .do not let it hang by brake hose. you got to remove hub nut. best way to do that is loosen it a litttle while tire still on weight of car keep wheel from turning .

May 03, 2009 | 1999 Daewoo Lanos

1 Answer

Daewoo 2004 matzi


A clacking or popping noise on turns means one of the CV joints is bad. A scraping sound means you need to oil the steering wheel support bearing, or maybe something like loose change fell between the steering shaft and collum.

Feb 11, 2009 | 1999 Daewoo Lanos

1 Answer

Need a Socket? Or special Wrench to take off my wheels!?


hi how are you if you dont have the wheel lock you can get the lug nut off by getting a nut and bolt remover kit some parts stors have them or from a specialty tool company (craftsman,snap-on) they both sell them and they will remove the lug nut.then just replace with a standard lugnut.

Feb 05, 2009 | 1999 Daewoo Lanos

1 Answer

Daewoo lanos


your brakes are keeping i on the dum try a puller and a hammer

Oct 18, 2008 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Daewoo Lanos Logo

Related Topics:

443 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...