Question about 2002 Ford Explorer

2 Answers

Auto Lock Activation

I would like to know how to activate auto lock in my Ford Explorer 2002 XLT Thanks

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 76,673 Answers

Deactivating/activating autolock
There are 3 methods to enable/disable this feature. One through your
dealer, the second with a power door unlock/lock sequence and the third
with the keypad.
Before following the activation or deactivation procedures, make sure
that the anti-theft system is not armed, ignition is off, and all vehicle
doors, liftgate and liftgate window are closed.
Controls and features
Power door unlock/lock
procedure
You must complete steps 1-5 within
30 seconds or the procedure will
have to be repeated. If the
procedure needs to be repeated,
you must wait 30 seconds.
1. Turn the ignition key to ON.
2. Press the power door unlock control three times.
3. Turn the ignition key from ON to OFF.
4. Press the power door unlock control three times.
5. Turn the ignition back to ON. The horn will chirp.
6. Press the unlock control, then press the lock control. The horn will
chirp once if autolock was deactivated or twice (one short and one long
chirp) if autolock was activated.
7. Turn the ignition to OFF. The horn will chirp once to confirm the
procedure is complete.
Keyless entry key pad procedure
1. Enter 5 digit entry code
2. Press and hold 7/8 control
3. Press and release 3/4 control
4. Release 7/8 control.
The user should receive a horn
chirp
to indicate the system has
been disabled or a chirp followed by
a honk to indicate the system has
been enabled.
Smart unlock
This feature prevents the driver’s door from locking while the key is in
the ignition. This feature will unlock only the driver’s door if the key is in
the ignition cylinder, the driver’s door is ajar and all doors are locked
using the interior trim switch. If these conditions are met, the entire
vehicle will lock and the driver’s door will unlock within 1 second.
Controls and features
127

Posted on May 15, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Will this work for child safety locks

Posted on Dec 24, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wire in a Ford PATS Transceiver F8SB-15607-AC Ignition Lock Cylinder and Key FOB Explorer


i've found a few references on how to by pass this but if you follow this link to the ford explorer forum you will get better info and advice from fellow explorer owners/mechanics who know the vehicle from top to bottom
2002 ford PATS transceiver XLT won start

May 21, 2014 | 1999 Ford Explorer

1 Answer

Auto door lock don't work, they click when activated. Also the door ajar light stays on and auto light does not work. F350 super duty 2002 ford


You might need to oil the locks. Our truck does that some times. We just spray some WD40 on the catches and keep clicking them back and forth till it sinks it. As for the ajar light, the sensor inside of the door jam might be damaged. or the switch on the lights is turned on. I did that once.

Feb 27, 2013 | Cars & Trucks

1 Answer

Where is the keyless entry module?


You can use the keyless entry keypad to
Lock or unlock the doors without using a key.
Open the liftgate window.
Activate or deactivate the autolock feature.

This code is located on the owner's wallet card in the glove box, is available from your authorized dealer via scan code or is marked on the computer module.

Computer Module location
1995 thru 2001 is located in the jack storage compartment in the rear of your Explorer. First remove the panel to the jack storage compartment. Towards the front of this area you should see a metal box this is your auto-lock module(way up front next to your rear left passenger seat). On the back side of this is your 5 digit code factory preset code. It is hard to get to. To see it you will have to loosen, pull, use a flashlight or a mirror but it can be done.

I have one 1996 Explorer XLT and find it there.

Hope helps.

Sep 19, 2011 | 1996 Ford Explorer

1 Answer

I have a 2003 Ford explorer xlt. How do I replace the cigarette lighter?


at the auto store when you get the replacement for the unit there will be instructions on removal and installation.

Oct 13, 2010 | 2002 Ford Explorer

1 Answer

2002 Explorer V6. Power door locks have stopped working.


Mine just started doing the exact same thing tonight. I disconnected the battery to change a DPFE sensor and when I reconnected I had this problem. I also have auto headlamps and they are not working either. I don't know what is wrong, I checked all the fuses also and everything looks good. I wonder if it is a relay??? I will make sure I respond to you if I find a solution.

Mar 28, 2010 | 2002 Ford Explorer

1 Answer

UNWANTED ABS ACTIVATION


a bad wheel sensor will cause this must go to auto zone or advance auto parts to get a free scan to find out which one it is.if the abs computer gets a bad reading it thinks that one wheel is slipping.and attempts to correct the problem.

Jan 07, 2010 | 2002 Ford Explorer Sport Trac

1 Answer

I need to know where to find the rubber seal that goes between fuel pump and the fuel assembly? i have checked all parts stores an they do not have it ?


1995 Ford Explorer - Carter Fuel Pump Lock Ring
Try going to Auto Parts Warehouse. Plug in your vehicle info.
Go to" fuel pump", and on page three is the lock ring and gasket. Don't know if this part is a fit for your vehicle, but there's several on line auto parts stores to look in.
Hope this helps....

Jul 19, 2009 | 1995 Ford Explorer

1 Answer

Flash lights on locking doors with control


he is pushing the button a second time which is unnecessary.
it will cause damage to the lock actuators. yours will do it if you push the lock button a second time, but i do not recommend as stated above.

May 15, 2009 | 2002 Ford Escape

Not finding what you are looking for?
2002 Ford Explorer Logo

1,135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...