SOURCE: 1993 Geo Storm |Transmission
There is no way they would leave you stuck with the engine!! However, the odds are that it should fit. First check the flywheel or flex plate. [Not sure if its a auto or manual.] If they bolt on, your are into installing the engine! Good Luck with it! Frankster016
SOURCE: I cannot figure out what the timing marks are.
there is a small mark on the cam pully that must point strait down to the mark on the crank shaft timing pully. the mark on the crank pully is a bit hard to see but it is a low spot on the inside area. also lines up with the keyway grove in the pully.
SOURCE: how to set the timeing on 91 geo storm
The timing marks are located near the top of the crankshaft pulley on the plastic timing belt cover. There is a notch in the pulley to mark TDC (Top Dead Center)
Align the notch with the 0 mark on the plastic cover to set your base timing.
Ground the proper circuit on the ALDL connecter located under the dashboard somewhere under the steering wheel. Check the manual for the proper circuit to ground.
With the engine warm and the circuit grounded. Set the proper timing. Un-ground the circuit and you are done.
SOURCE: how to change fuel filter on a 91 geo storm gsi
the fuel filter is direclty below the brake booster mounted on the left side fender when your facing the car from front but be careful as to not twist and break the metal hoses on the fittings on the filter
SOURCE: firing order diagram 1992 geo storm SOHC 1.6L
1,3,4,2 is the fireing order. I got the answer from the haynes manual for the car.
57 views
Usually answered in minutes!
×