Question about 1999 Chevrolet Silverado 1500

1 Answer

MAF sensor and injectors

I have a 1999 chevy silverado 1500 4x4 with a 5.3l vortec v-8 engine. I am having problem with two of my injectors being clogged and finding exact instructions on how to locate and remove the MAF sensor so I can clean it because I have an aftermarket K&N air intake system, and its possible that I may have over oiled it and thus clogged the MAF sensor?

Posted by on

  • Anonymous Mar 16, 2014

    location of maf sensor on 1996 chevy k1500 5.7

  • Anonymous Mar 16, 2014

    location of maf sensor on 1996 chevy v-8

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 599 Answers

The mass air flow sensor is located between the air filter housing and the air inlet to the intake manifold, remove the two band clamps holding the maf sensor, clean when cold with CRC mass air flow sensor,remember to take off the three wire plug to the maf sensor,get back to me if you need more help,please rate my fix as i strive to be the best,problems,get back to me

Posted on May 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Where is the crank sensor located on the motor for a 1999,5.7 Vortec, engine and what tool will i need to replace it may i have a picture veiw? or how do i go about looking information


1999 chevy 1500 series has spark getting fuel wont start replaced crank position sensor cap n rotor getting backfire through throttle body.

Feb 05, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Chevy truck '02 surges between 45 and 55 mph


you should change the tps( throtal position sensor) this can cause that problem

Aug 15, 2009 | 2000 Chevrolet Silverado

1 Answer

1999 Silverado 5.3L hard to start right after turned off


First check your air filter, and change if needed. Check your engine ground connection. Check for loose connections in the ignition sysem. Check your idle control system/ sensor. Good luck, and let me know what happens.

Jun 01, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

1999 chevy blazer wont start


THE FUEL PUMP IS BAD.

if your losing fuel pressure after the pump runs the drain back valve in the pump has failed.

and i doubt that you are seeing enough fuel pressure to run a vortec engine.

low fuel pressure equals a non running vortec

Apr 11, 2009 | 1999 Chevrolet Blazer

3 Answers

Where is the egr valve located on a 1999 silverado 5.3 vortec


try cleaning the inside of the MAF sensor with CRC brand MAF cleaner, it is availiable at any auto parts store for around $5

Feb 27, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

98 chevy 1500 4.3L vortec misfire problem


These have a real problem with the distributor caps, i would try that

Feb 18, 2009 | 1998 Chevrolet C1500

2 Answers

I have a 1999 chevy silverado 1500 z71 4 wd.It was skipping so i replaced plugs and wires it then started skipping worse and i pulled the MAF sensor code from the computer so i replaced it then i also...


I had the same exact problem at 175000 miles on my '99 Silverado..after paying the garage several times to read the computer codes to me and ex-plain that 1st I needed an $899.00 head gasket repair, and then just a $250 injector replacement, I decided to run some injector cleaner throguh the system...guess what?............I cetainly am glad I didn't have the head gaskt repaired or the injector replaced...problem fixed

Dec 28, 2008 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

1,276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...