Question about 1999 Isuzu Rodeo

1 Answer

Oil sump plug location of holden rodeo 1999 - 1999 Isuzu Rodeo

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 84 Answers

Ok.....so when you get under you rodeo....look for a big pan....it should be black in color.......and at the very end of it,,you should see the plug..

but dont get near the tranny or you could end up getting the wrong plug....and you will have cherry tranny fluid all over the place.....

good luck XD

Posted on May 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the holden vectra drain plug situated


Im assuming you mean the engine sump drain plug to drain the engine oil.
Its located on the bottom of the sump depending on which year model yours is otherwise look at the back emgine of the sump.
Its a torqs fitting plug looks like a star in the centre .to undo it you will need a t45 torqs bit..

Feb 13, 2015 | Holden Cars & Trucks

1 Answer

Oil light is on and engine in limp mode


check the oil level in the sump, coolant level, coolant temperature (overheating), transmission oil level if auto. The limp mode is energised by any number of sensors that register a fault that is detrimental to the engine/ gear box. Run the fault codes and repair any faulty units . Reset the CPU with a scanner .

Jul 02, 2014 | 2005 Holden Rodeo

1 Answer

The location of oil filter on 2005 rodeo


drivers side, from bottom, in front of exhaust, will leak oil when undone. take a little time to position some news paper , to channel spilled oil clear of vehicle, it will drip down cross member otherwise.

Dec 26, 2013 | 2005 Holden Rodeo

1 Answer

Location of oil filter


Going on the standard 2005 model holden rodeo you will find the oil filter located at the front of the engine,down the bottom .you will need to gain access from under the vehicle and there should also be a stone tray to remove.

Dec 26, 2013 | 2005 Holden Rodeo

1 Answer

Where do I top up the transmission fluid on a 1999 holden rodeo? There is no dip stick or filler plug?


There is a fill plug on the side of the transmission under the truck.

Jul 12, 2012 | Cars & Trucks

1 Answer

Holden rodeo 2007 using oil


It could be one of a number of things. the valve stem seals maybe worn if the car has done a few km's.
worn piston rings casing oil to get into the cylinders and burn with the fuel also caed by high kms'.Does the water in the radiator seem to have an oiley feel if so you may have a blown head gasket it may pressurize the radiator but tthere may also show with the color of the oil in the sump..

Jun 13, 2012 | Holden Rodeo Cars & Trucks

2 Answers

2003 holden rodeo auto gearbox. I have taken the oil from the bottom of the sump nut out and have been replacing the oil from the dip stick. Is this correct and how much oil do I replace, or is it just...


Taking the oil from bottom sump is correct n yes putting it back via the dip stick is correct too. But b4 u guage, start up the car, engage gear with leg on the brakes if stationary, try reverse too 4 a while, legs on brakes again if stationary bring to neutral, still on hand brake up. Then guage to d required dip stick mark. Note: b4 starting up n engaging gears be sure u ve put in some oil first n pls do not let it over guage, go past the mark on dip stick, if it does drain a bit at a time till u get it right.

Sep 10, 2011 | Isuzu Rodeo Cars & Trucks

1 Answer

I have a 1989 2.6lt holden rodeo which is losing water and overheating. I can't find any leaks anywhere. Is it a blown head gasket or a cracked head?


the water is most likely making its way to the sump and mixing with oil creating a milky looking oil or exiting via the exhaust from a leak into a cylinder. sorry head has to come off and check timing cover too for corrosion and leaks

Jun 22, 2009 | Isuzu Rodeo Cars & Trucks

1 Answer

Oil pickup/filter/pump problem with Holden Jackaroo 1993 4x4 V6


the motor will deffinatly have to be pulled. There is not enough room underneath to remove the oil pan.

Feb 04, 2009 | 1993 Isuzu Rodeo

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

Related Topics:

403 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...