Question about 1999 Dodge Intrepid

1 Answer

Where is the oil drain plug for a 2002 dodge intrepid

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 135 Answers

Raise vehicle with ramps or jack secure with jack stands,or raise car on a lift. look on side or back of oil pan to find drain plug.

Posted on May 13, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: find location for oil filter for oil filter for dodge intrepid

What engine? 2.7 passenger side on the bottom next to oil pan. 3.2 and 3.5 Drivers side coming off the side of block, near the front under the exhaust manifold.

Posted on Mar 24, 2009

old marine
  • 1986 Answers

SOURCE: dodge intrepid 2002

The knock sensor is threaded into the block of the engine, just below where the cylinder head sits. You will need to remove the intake plenum (upper and lower) to access this part.

Posted on Feb 05, 2009

t1randa
  • 27 Answers

SOURCE: Serpentine/drive belt routing diagram of a 2002 dodge Intrepid needed.

check dodge website you have to register to get the owners manual which has or if you have your owners manual

Posted on May 29, 2009

bschilz
  • 2049 Answers

SOURCE: How to drain the radiator

Warning first...always work on radiator when temperature is low to reduce chance of extreme burn. That being said,
Look on the bottom of the radiator for a "pitcock" valve. It will look like a big wingnut. Turn it counterclockwise to open the valve and the radiator will drain.
If for some strange reason there is no valve on the bottom of the radiator, disconnect the lower radiator hose to drain.

Posted on Aug 09, 2009

  • 299 Answers

SOURCE: where is the oil drain plug in my 2008 Dodge

it will be at the lowest point of the oil pan

Posted on Sep 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dtc Code P2314


2002 Dodge Intrepid Ignition Coil Circuit Codes: Electrical ...

www.2carpros.com/.../dodge-intrepid-2002-dodge-intrepid-ignition-coil...
Aug 13, 2008 - 2002 Dodge Intrepid 6 cyl Front Wheel Drive Automatic 130000 miles. Getting the following codes. P0353 P2302 P2305 P2308 P2311 P2314

What are 2002 Dodge Intrepid trouble codes PO442 and ...

www.answers.com > ... > American Cars > Dodge > Dodge Intrepid
What does the Error Code P0846 on 2002 Dodge Intrepid mean? .... Trouble code P2314 means: Ignition coil E, secondary circuit - malfunction Trouble code .

Oct 29, 2015 | 2002 Dodge Intrepid

1 Answer

2002 dodge intrepid gets to operating temp oil light comes on tep gets high runs rough and dies no ticks runs smooth until it reaches operating temp


put an engine flush in first . run the engine on tick over .till oil is hot then drain it. do an oil and filter change may have a build up of carbon in the engine .the flush should deal with that .use 20/40 oil .

Dec 21, 2013 | 1997 Dodge Intrepid

1 Answer

Where is the oil drain plug on a 1999 dodge intrepid 3.2 liter


There should be a drain plug on the oil pan and it is advised to have a metric socket set with 6 point sockets, so you don't round it off. It's usually cheaper to take it to a good oil change place to save the headaches.

Nov 04, 2010 | 1999 Dodge Intrepid

1 Answer

What do you do if there is too much oil in a 2000 dodge intrepid?


Take the drain plug out and drain some oil out, put the plug back in and check the level, do this repeatedly until you are no longer above full and if you drain to much just top it off to full. To go from low to the full mark you only need one quart.

May 20, 2010 | 2000 Dodge Intrepid

1 Answer

Fuel tank drain plug location on 2002 Intrepid ?


That car does not have a drain plug on the fuel tank

May 04, 2010 | 1999 Dodge Intrepid

1 Answer

2002 dodge intrepid se 2.7 engine light on got


Anytime a Chrysler product of this year has a check engine light, get it to a dealer immediately. The 2.7 liter engine is notorious for oil sludging. This can be a dangerous problem that can destroy the engine.

Your problem may have nothing to do with oil sludging, and I hope it doesn't; but don't take a chance.

Google "Chrysler engine oil sludging."

Oct 20, 2009 | 2002 Dodge Intrepid

1 Answer

The oil light comes on at low rpms but goes off when engine reaches 1500 rpm on a 2002 Dodge intrepid


I would get to a Dodge dealer as quickly as possible.

As I recall, these years in the Chrysler products were very prone to a condition called "oil sludging." This can lead to a seized engine, which can lead to a $3,000-4,000 engine replacement. The oil light might indicate low oil pressure, which could be related to plugged oil passages as a consequence of the sludging.

Dodge has paid for replacement engines for a lot of cars from the early 2000's; however, the car owner has to be persistent.

Check Google for "Chrysler engine oil sludging." You will get a real education on the subject.

Oct 11, 2009 | 2002 Dodge Intrepid

1 Answer

I need to replace the oil pan on my 2002 Dodge Intrepid with a 3.5 Liter engine. What are the steps. Especially with the metal ubber pan gasket.


1.put car on a lift. 2.Drain oil. 3.make sure to have exact oil pan ready with seal in hand. 4.unscrew the bolts in a x fashon. 1-6 3-4 2-5 remove oil pan. 4.Clean all around where the oil pan used to be. 5.Attach new seal and oil pan. hand tighten all the bolts in a X fashon then tighten with a wrench or socket. 6.make sure oil drain plug is on good. 7. put new oil in typically 5 quarts. 8.put car on ground 9. All done.

Sep 02, 2009 | 2002 Dodge Intrepid

1 Answer

Changing the oil


The drain plug is on the oil pan, bottom of engine. Use an adjustable wrench

May 03, 2009 | 2002 Dodge Stratus

Not finding what you are looking for?
1999 Dodge Intrepid Logo

Related Topics:

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...