Question about 1993 Honda Civic 4 Door

1 Answer

I have an oil leak on my 1994 honda civic

It seems to be leaking more to the front of my car not under the oil pan anybody know where or why its leaking i cant find the place all i know is oil keeps ending up on my tranny

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Loose oil filter or valve cover.

Posted on May 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil leak at bottom of timming belt cover


what engine.? lots of engines, used. and 21 models of civic, USA.
its usually.
1: valve cover, (yes, most can leak from top down behind the belt.
2: cam seals
3: crank end seal
4: oil pump seals.
6: oil pan ( last choice)

finding oil leaks takes hard work , clean, it find it .
or use the dye kits.

gravity and wind, allows it to go where ever IT wants.
so it must be clean first to find it.. see?
or use the dye kits, it shows a live leak best.

ever look here?
http://estore.honda.com/honda/parts/view-honda-parts-catalog-detail.asp?m=1997-civic-2-dx-4at&sn=&b=E++09&dl=

question, at the 60k mile service points. you check lash, settings.
with a new timing belt. and at such point, a new valve cover gasket gets fitted, did you? if yes, its not leaking if not>????
the front edge of the VC gasket, leaks down behind what i call
the VC leak hidder, tin pan. plate. behind the cam cog
is a plate, and the VC leaks down from there to the cam seal
then down front of engine, then past crank seal the, to cover.
seen this on all most all OHC engines...
cause, nobody does the 60k or does it and uses the old gaskets.
id look there first. but id dont have service history.
start high work down due to gravity.....
the FSM is here.
see that too. "free" too
http://hondatech.info/downloads/Auto/Manuals/Civic/

Dec 17, 2013 | 1997 Honda Civic

1 Answer

94 Pontiac Sunbird V6 Oil Leak


Look at the top of the engine /trans connection area for a leaking seal.Clean that area then check there.

May 28, 2017 | 1994 Pontiac Sunbird

1 Answer

How to replace oil filter with new 1 on a 1994 honda civic hatchback


The following procedure explains how to change the oil, and filter.
  1. Before changing the oil, see that the vehicle is situated on a flat surface with the engine warmed; warm oil will flow more freely from the oil pan.
  2. Turn the engine OFF, open the hood and remove the oil filler cap from the top of the engine valve cover. CAUTION
    Hot oil can burn you. Keep an inward pressure on the plug until the last thread is cleared, then, quickly remove it.
  3. Place a container under the oil pan large enough to catch the oil. A large, flat drain pan is the most desirable.
  4. Remove the oil drain plug. Allow the oil to drain completely.
  5. When the oil has finished draining, install the drain plug, then tighten until just snug. Use a new washer (if applicable) on the plug.
  6. Move the oil drain pan or use a second pan under the oil filter; the filter retains some oil which may drain when it is removed.
  7. Using an oil filter wrench, loosen the filter by turning it counterclockwise, then unscrew it by hand.
  8. Using a clean cloth, wipe the filter mounting surface of the cylinder block. Apply a thin coat of clean oil to the new filter gasket and install the filter by hand carefully threading it on turning clockwise. Tighten it as much as you can by hand, then use the wrench to turn it an additional 1/2 to 3/4 turn.
  9. Remove the drain pan from under the engine. NOTE: Used engine oil is an extreme environmental hazard. Proper disposal of used engine oil is very important. Rather than dumping the oil in storm drains or throwing it in the trash, you should take it to an approved recycling center. Many shops will accept used engine oil. If you are uncertain where to take the oil, many local municipalities can direct you.
  10. Add the correct amount of recommended oil into the filler hole on top of the valve cover. Be sure that the oil level registers near the full line on the oil dipstick.
  11. Install the filler cap. Start the engine without touching the accelerator pedal and allow it to idle. The oil pressure light on the instrument panel should go out after a few seconds.
  12. Run the engine for 1-2 minutes and check for leaks. Turn the engine OFF, then, after a few minutes, recheck the oil level; add oil. Be sure to check for oil leaks. If you find any, correct them immediately.
  13. Recheck and/or refill the engine with oil. NOTE: If the filter leaks, make sure the old filter gasket is not on the mounting flange. If the old gasket is not on the flange, tighten the filter a little more. If it still leaks, try another filter.

tecnovative_70.jpg

Feb 16, 2011 | 1994 Honda Civic

1 Answer

Hello. I have oil leak on 97 civic that covers the bottom of egine backwards. Could it be as simple as the oil pan gasket needing replaced? I am now having to replace a quart a little over a month...


First have ur engine DEGREASE and pressure wash to check where could be the leak coming from, u could just go to ur garage service or anyone has a HiGH PREASSURE washer just to dislodge the oil from ur engine!
U have to check the FRONT CRANKSHAFT OiL SEAL, valve cover gasket, and the (ignition)distributor oil seal(this is the area usually where oil coming out from Honda cars)

Nov 29, 2010 | 1997 Honda Civic

1 Answer

Why does my 1994 honda civic waste so much oil. i pour oil every other day but i have no leaks


My friend;
Try this;
1. You may use bad grade {brand} oil.
2. You could be driving fast {speeding up}.
3. You may have bad cylinder / piston ring, which causing oil to leaks inside the cylinder & burn it up through exhaust.
4. Check the quality of your oil: your car must or should use 20W-50 viscosity .
5. Check your radiator it should NOT has oil mixed with its water.

Try it, & PLZ; let me know if I add any benefits to you.
I hope I add some thing valuable to you.
Regards;
MAR;
soer2@yahoo.com

Nov 09, 2009 | 1994 Honda Civic

2 Answers

Oil in my honda civic 1991 is dripping all over but only when the car is running any ideas?


your the only one that can answer where, check the oil filter and the oil light switch first.

Oct 02, 2009 | Honda Civic Cars & Trucks

1 Answer

1994 honda civic cx


yea, you are burning oil. piston rings, or an oil leak from some where else

Aug 18, 2009 | 1994 Honda Civic

1 Answer

Motor Oil leaks from 1999 Honda Civic EX


make sure they are tight
could be time for head gaskets
make sure the old gasket from the old filter came off the block sometimes they come off old filter and stick this causes a leak due to improper seal.

Apr 10, 2009 | 1999 Honda Civic

Not finding what you are looking for?
1993 Honda Civic 4 Door Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...