Question about 1994 Chevrolet S-10 Blazer

1 Answer

My ignition fuse in my 1994 chevy blazer s 10 keeps popping. It started about a month ago after hitting a pot hole in the road. When it pops, it causes my spedometer to stop working and my fuel gauge. It also drains my battery, not giving my truck the power it needs to drive. I'm at the point where I am changing the fuse about 7 times throughout the day. My dad notice that the starter was arcing and replaced it for me thinking it would help but it did not.

Posted by on

  • Tiffany Buckhalter
    Tiffany Buckhalter May 14, 2009

    my dad knows how to do the electrical he just wants help pointing in the right direction. he looked at the engine wiring harness, the alternator wires and the fuse box and saw nothing wrong.

  • yadayada
    yadayada May 11, 2010

    this will not be fixed over this keyboard, take it to the dealer where they can see what wiring u have damaged.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 218 Answers


Posted on May 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

I have a 1999 Chevrolet S10 Blazer. In the morning it will fire right up and run for all of 10 minutes or so, then shut off an not start again for about 30 minutes or so.

Could be the computer not good PCM also just because the ignition module has been replace it could be defective I had new parts good bad you can go crazy trying to fig it out then it might be a new defective part or module igintion good luck

Oct 03, 2015 | 1999 Chevrolet Blazer

1 Answer

How do the rods attach in door latch assembly on a of 1994 Chevy Blazer

rod clips can be a pain...the clip keeps the end from popping up out of the hole they swing over the rod right by the "hook" part they can be tight to pop off that is if they are the plastic type the steel type slide onto the groove in the hook and have a little tab the locks into the arm the rod goes into you need a small screwdriver to release this type be prepared for sum stress

Aug 15, 2014 | Cars & Trucks

1 Answer

Fuse (10 amps) that provides juice to temp gage, rpm, speedometer and fuel gage keeps blowing up.

Try to use a 20 fuze one if it burns out that quick use a bigger recemend using a 20 or 25 fuze

Jul 27, 2014 | 2001 Chevrolet Chevrolet Blazer

1 Answer

Fuse keeps popping out (10 amps)

Sounds like you have a short in one of the components or wires that fuse controls.

Jul 26, 2014 | 2001 Chevrolet Chevrolet Blazer

2 Answers

2001 blazer makes a grinding or clicking noise during acceleration.

Yes, you need a brake job or clean the brake pads by taking off the tires, then the drums, wipe the inside of the drums of dirt, wipe the brakes off, and reassemble.

May 24, 2017 | 2001 Chevrolet Blazer

1 Answer

I have a fuse that keeps blowing ign/gauge fuse 1994 chevy s-10 blazer

Mine was the o2 sencor on the pipe not on Cadillac Converteri sprayed p B a blast on it and it started blowing then ish infuse because I tryed for 2months to get the o2 sencer off well right afterI sprade it. It started blowing the fuse. I unpluged it and I stoped so check your try unpluging i

Aug 19, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

Ignition switch

You wrote ignition switch/lock cylinder. Which part did you replace? The ignition switch or the ignition lock cylinder? The electrical ignition switch is what is bad.

May 15, 2009 | 1997 Chevrolet Blazer

1 Answer

1997 chevy blazer ignition switch

1997 blazer put car in park shut it off but, key won't turn far enough back to come out

May 12, 2009 | 1997 Chevrolet Blazer

5 Answers

93 chevy s10 blazer fuel pump replacement

try yhe pickup coil or ignition module wich are both located on the distributor or the igniton going through the same thing.all i have left to try is the ignition module.if i get it ill be sure to let you know

Jan 01, 2009 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides