Question about 2006 Dodge Magnum

2 Answers

2005 Dodge Magnum error code...

2005 Dodge Magnum 2.7 came up with 0038 error code. I took it to have it smogged and the result was a failed test and the details read HO2S Heater control circuit high (bank 1 sensor 2). I changed out the O2 sensor on the driver's side after the cat (figuring that the driver's side would be bank 1). I reset the code (disconnecting the batteries neg terminal) and drove for about 10 minutes the check engine light came back on with the same error code. Should I change out the other 02 sensor or is there another way to reset the code??????

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Dodge Master
  • 3,854 Answers

Your heated O2 sensor has a heeater problem most likely. Most likely time to change out your HO2 sensor. Most cars actually have only primary heated. Not sure for this application but would thus assume the primary sensor or otherwise known as precat O2.
With a sensor high you have high voltage back to the pcm thus most likely shorted heating element.

There is an outside chance of a cross short to the ground circuit of your O2 sensor. If after replacing your sensor you still have a problem then start looking for this.

I see you went to the auto parts store and got an HO2 sensor (Should be a 22mm or 7/8" -- same size) and replace the Primary and if that do not solve the problem, then see if you have a heated postcat HO2 if not then see above.

Good luck and hope this helps, oh and Bank 1 is where your #1 cylinder is.

Posted on May 13, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where is the knock sensor in dodge magnum v6 2.7l 2005i want quit the old and put new but idk the localization

Posted on Nov 28, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Dodge Magnum - 3.5 litre - 128,000 miles - P0016. Scan tool identifies both cam and crank to be in sync, yet code returns after about 2 minutes of running.


I was going to say that the timing belt had failed, if this wasn't replaced do so, and also replace the water pump as if it fails it will jump the T. belt and bend the valves.

Jul 31, 2012 | 2005 Dodge Magnum

1 Answer

Bas light dodge magnum


Same thing happened to my 2005 dodge magnum. Took it to the shop, we thought it was a computer issue. Flashed the computer and it didn't help. It ended up being the thermostat and some other parts. The shop had to remove the whole front grille to replace a part that went straight through the top of the engine. The part is plastic and had cracked and was slowly spewing coolant all over the engine. The car was basically overheating but so little that it was not evident at first. Once they replaced all of that the lights stopped coming on. Very frustrating to say the least.

Dec 03, 2011 | 2005 Dodge Magnum

1 Answer

Wont pass smog due to malfuntion indicator light on a pt cruiser 2005 everything pass but failed this what can we do to fix it


YOU NEED TO HAVE VECHICLE CODE SCAN FOR FREE AT ANY AUTO PARTS STORE THEY WILL GIVE YOU THE CODE THAT CAUSING CHECK ENGINE LIGHT TO FLASH.ITS MORE LIKELY EVAP LEAK THAT WILL CAUSE YOU TO FAIL SMOG TEST.

Sep 12, 2011 | 2005 Chrysler PT Cruiser

1 Answer

My turn signals/ cruise control/wind sheild washers and horn all stopped working all fuses check out to be good is there another module that controls all of these devices? 2005 dodge magnum se 121,000...


I wonder if one of the vehicle computers has failed they sometimes run almost everything you described I would take it to a dealer and get your computer scanned for error codes

Apr 18, 2011 | 2005 Dodge Magnum

2 Answers

97 CAVALIER (Z24) FAILED SMOG TEST


No the water pump will not affect the smog test. You probably failed the idle?
Usually with this age of vehicle you can replace the o2 (oxygen) sensor and it will pass. Cleaning the MAF if it has one cant hurt either if you do it right.

Mar 30, 2010 | 1997 Chevrolet Cavalier

3 Answers

Oil lights keeps coming on in 2005 dodge magnum


how do i turn the oil light off in my 2005 dodge magnum?

Oct 08, 2009 | 2005 Dodge Magnum

1 Answer

2005 dodge magnum


wring the wreckers and see if you can get a second hand one, even better if there is a self serve wreckers near you go there your self and remove the part you need

Oct 01, 2009 | 2005 Dodge Magnum

1 Answer

2005 magnum esp/bas and engine light on


you need to see what the eng lite for if there is a trans codes usually the pcm wont let the speed go over 40 stays in safe mode untill you fix the problem or change the sensor,for the esp you need to chage the esp sensor and recalibrate by the dealer

Jul 20, 2009 | 2005 Dodge Magnum

1 Answer

Dodge magnum has lost powre to horn,turn signals,brites,cruise,mi


the body control module has most likely failed, have the dealer test it.

Jun 07, 2009 | 2005 Dodge Magnum

1 Answer

2005 dodge magnum RT w/ hemi


take it to autozone or advance auto to have the check engine light code read for free. take a pen and paper to write down whatever it is and we can go from there.

Sep 25, 2008 | 2005 Dodge Magnum

Not finding what you are looking for?
2006 Dodge Magnum Logo

688 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...