Question about 2002 Chrysler PT Cruiser

1 Answer

I dont know where the three wires that plug into the elec. fan connect to the block

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 151 Answers

Dark green - pin 1 Ground - pin 2 Yellow - pin 3

Posted on May 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1988 w/2003 engine. How do I connect new harness?


WOW?
yes, the new ECU;PCM uses a real electronic 3 wire
hall sensor for speed, (or uses ABS if opted)
swaps are complex. we need
what you had before the swap (drive line)
and what was removed from the 2003... every part.



http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Aug 26, 2015 | Jeep Wrangler Cars & Trucks

1 Answer

2010 grand vitara with elec isues first the hi-beam lights not working?then they started working now the climate control heated seats and sun roof not working?any ideas? thanks


you dont know how to test a fuse. and are doing electrical work>?
ok , working with out the FSM>?? why do that, its 4 bucks, 1 day pass.

the fuses are best tested in live circuit. 12vdc on both sides, key on.
bingo
or unplugged with any DMM or ohmeter ever made.
resistance range Rx1 or RX2
reads near zero ohms is good
reads infinity , is bad.
open bad, shorted good. end fuse 101;.

Sounds like wiring issues.
Did you first scan the PCM/?
see if you have DTC errors.?
the newer cars monitor power now. so not looking missing that boat

Sep 12, 2014 | 2010 Suzuki Grand Vitara

1 Answer

Cooling fans on aztek no coming on, ran hot wire to fans and works. checked fuses, jumped wires at temp. sensor and fans ran after shutting ignition off for aprox. 30 seconds, replaced temp. sensor and...


there are 4 steps to check and you've mentioned all but one the relay which cuts the fan on'off. At an elec shop you check in this order power to fuse block, fuse & output side, temp sensor, relay, and fan motors. Get a new relay

Apr 28, 2011 | Pontiac Aztek Cars & Trucks

1 Answer

MY 1998 SATURN DOESN'T SHUT OFF FOR 30 SECONDS WHEN U TURN ENGINE OFF HELP


One thing I can think of that will do that, is if some one wire your radiator elec. fan motor direct where it runs all the time, the fan motor will act like a alternator, where it will put voltage out to the ignition system, and till it stops spinning it will power the engine elec. system, one way to check is disconnect the cooling fan elec. plug (harness) and start the engine, if it turn off right away that your problem.

Jul 26, 2010 | 1998 Saturn SL

1 Answer

The elec fans will not come on\r\nthe temp gage


Hi: Your are sure all your Replays are good,And all your Elecrtical Connections are Good Fuses ,How about your Your Adjustable Screw in Thermastat? Have You Checked That,It Works the Same way your Home A/C would work Cuts off at the High Temp setting and Comes on when it Cools Down to the Low Thermastat Setting.This is Adjustable I Beleive.Call To Verify my Solution with a Dealer. But Sounds like it could be Not Funting Properly. Hope this Gives you another Solution to Check if you already have'nt Checked. from the WYOCWBOY

Jun 02, 2010 | 2002 Chevrolet Venture Passanger

2 Answers

How do you change the spark plugs in my 95 buick century ?


Use a spark plug socket wrench, remove the plug wire, unscrew the old spark plug, screw in the new spark plug, and re-connect the plug wire. Do 1 at a time

Aug 03, 2009 | 1995 Buick Century

1 Answer

1998 caviler


Look on your radiator and you should find a "bolt" head, about 20mm, with 2 wires plugged into it.
This is the fan thermo switch, with the ignition on, but engine not running, connect these wires together by shorting a screwdriver accross and the fan should cut in.
If the fan works, then the switch needs replacing, just unscrew and replace.
If the fan doesn't work then there is a problem further into the circuit, fuse, relay or broken wire.

Jun 14, 2009 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
2002 Chrysler PT Cruiser Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...