An expert who has achieved level 3 by getting 1000 points
An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.
An expert that got 20 achievements.
An expert that got 10 achievements.
Re: Blower motor in 1993 dodge dakota
U must have knocked the vacuum hose off when u changed the motor, that (vacuum) is what moves the air to the different outlets, the vacuum comes from the engine and enters the cab on the passenger side..
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
this sounds like the blower motor is drawing more amps than the circuit is designed for causing the fuse to blow. disconnect the blower put in new fuse it probably won`t blow telling you that you need to replace the blower motor.
first when it comes on is it only in the hi position? if so the resistor needs to be replaced again (just because its new does not mean it works) and the blower speed switch in the control panel needs to be replaced
Check the blower motor speed control resistor pack is ok.
(The resistor pack is usually located in the blower fan ducting in the air flow).
Check condition of electrical connection terminals on the blower motor circuit - these terminals pass considerable current and over time may fatigue overheat and loosen.
Check operation/replace any blower motor control relay,
Check the blower motor will run if +12v directly applied to the blower motor.
Check operation of the blower motor speed control switch is ok.
2. remove lower right undre panel silencer duct
3. remove the blower moter connector from the resistor block
4. squeeze the blower moter wiring gromment and push the gromment throw the blower moter housing cover
5. remove blower moter housing
6.romove the screws holding the blower moter down
to put back on do the steps back werds