a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi there, yes they do have a cabin filter, it located under the bonnet on the passenger side. You will need to remove the cowling on the left side, then just loosen the 3 boots holding the washer tank but don't remove them, you can then pull it forward a it and expose the housing for the filter, push the clips out of the housing and pull it strate up, then remove the old filter and replace it with the new 1. Note on the bottom of the housing you pulled up has 2 tabs on it, make sure they are located and just reverse your process and put it back together, hope this helps
You talking engine air filter or cabin filter? Engine air filter is located in air box in engine compartment.. unclamp , open box , remove old filter, wipe out box, replace new filter , reclamp box.
Cabin filter located under cowl just below windshield. remove cowl bolts / plastic rivets. pull off cowl .. filter is in center and slides out like a drawer.. slide in new filter and replace cowl.
The cabin filter is on the left side of your heater assembly down by your floor outlet. You just about are required to get up side down on your seat and lay on the floor. Your filter actually comes out in sections and is reinstalled the same way. This is not a fun task of a poor design.
The cabin air filters are located in a box that is part of the blower motor housing.
To access them, you will need to get behind the glove compartment. Open the glove box and you will see the stops/supports on each side of the door. They are held in by clips, so push from the outside inward and pop them loose. At this point, the glove box door will open fully and dump its contents on the floor.
Now, look behind the door, you will see the blower housing. On the front of the housing is a plastic cover. Remove the cover and you will see two tabs. Pull the left tab to remove the first filter and its carrier. Slide the tab on the right to the left and remove the second filter. Remove each old filter from its carrier and replace them with the new filters.
Reverse the process to put everythig back together. Clean up all that stuff on the floor. ;)
IF YOU WANT TO REPLACE THE CABIN FILTER YOURSELF. SAVE MONEY Open the glove box and push in on the sides. There are two tabs located here (one on either side) Simply pushing in on the side of the glove box and pulling it forward (allowing the tabs to clear the console/dash) finishes this step. Pull the glove box towards you. There are a set of notches on the bottom which clamp to the inside of the glove box which must be pulled free. Just pull the glove box and it should come off. You should now see the air filter cover. Its held in place by two upper tab/slots and two lower clips. Pull down on the outer cover to free it from the tabs, then pull out towards yourself and it should come free, exposing the air filter. Remove the old air filter and replace it with the new one. You may need to pinch the old filter horizontally to get it to squeeze out of the compartment. Its flexible and being tossed anyway, so don't worry about damaging it. As you can see at 12,680 miles the cabin air filter is quite dirty. The new filter slides in the same way the old one came out. Make sure the filter is sitting flush in its compartment, and is not angled or tilted. Make sure the AIR FLOW ARROW POINTS DOWN. Failure to adhere to this step could result in the climate fan being damaged, or a massive loss of horsepower (unconfirmed). Put the cabin filter back on. Make sure after putting in the upper tabs to SNAP the lower section of the cover on by pressing on the clips on the bottom they are beveled to snap into place under the filter assembly. After this step, put the glove box back on, and your done!
Make sure you clamp the bottom retainers very carefully. I learnt the hard way by breaking one. You will need to put your thumb or finger on the retainer and gently slide it in. New glove box costs over $100.
Just to the right and above the accelerator pedal you need to remove the left sound insulator panel. Then remove the filter access cover by pushing down and then pulling out. It kinda pops off. Remove the tape on the first filter and then remove the filter by pulling the filter tab. Remove the tape on the second filter and then remove second filter by pulling the filter tab. Remove the third filter by pulling the filter tab. I know you didn't ask about all that but just in case you wanted to replace them.
(2) remove the old cabin air filter. This is located under the glove box near
the footwell light. You can get to the filter by removing the plastic
covering under the glove box. This is held in by 2 torx screws. Remove
this, and you've reached the CAF.
(3) slide out the old CAF.
(4) slide in the new one. Really, there's nothing more than that.