Question about 1999 Mazda 626

1 Answer

Where is the blower motor resistor on a 1999 mazda 626 ?

Posted by on

  • tim_rober42 May 12, 2009

    autozone dont appear to cover the 1800 but you have helped with the location thanks.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

For the most part it is under the dash on the passenager side and it has two screws and a plug in the middle try this website to see if they have your car listed if they do you be able to get pictures and diagrams showing you how to repair you car and check on a price at the same time here is another website to try for auto repair information i hope i have been some help to you Michigan Man.

Posted on May 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need to find a fan switch resister for Mazda Capella 1979

The resistors are a pack of three situated in the blower housing. Any fan resistor unit will do the job even the ones from the rx series.

Oct 28, 2013 | 1999 Mazda 626

2 Answers

My blower motor works sometimes, but sometimes not. It seems to work better if I am at higher speeds for a while. Is this most likely a blower motor or resister issue?

bet on the motor on this one,sounds worn,at higher speeds the vibration can help the brushes in the blower motor work better.
you can test my theroy by giving the blower mortor a sharp tap while its running to see if it increases in speed.
if it does then you have your answer.
the brushes in the blower motor build up carbon deposits over time and cause the motor to slow tapping the motor the deposits release and allow the current to flow more freeley.
good luck,Gary

Oct 24, 2013 | 2001 Mazda 626

1 Answer

Fan only works on 4 in my mazda 323f bj modle

this problem is caused by the fan speed control resistor, it is located next to the blower motor in the heater duct work.

Feb 23, 2010 | 1999 Mazda 626

1 Answer

I cand get any warm or cold air thru the ventilation.

only works on 4 because blower motor is getting direct live feed try changing resistor normally located near blower motor if looks ok check switch

Aug 20, 2009 | 1997 Mazda 626

1 Answer

Need picture diagram of a 1999 mazda 626 thermostat housing v6 2.5

where is the thermostat on the 1999 mazda 626 i need a diagram... the book shows me a different motor....

Jul 13, 2009 | 1999 Mazda 626

2 Answers

Im trying to replace the alternator on a 1999 Mazda 626

Yes, I experienced the same thing with mine... you have to losen the 2 motor mounts on that side and lift the motor up about 3 ". I worked at a garage so I had access to an engine hoist. Try using a jack from underneath. Nice engineering from Mazda!!!

Jun 08, 2009 | 1999 Mazda 626

2 Answers

Blower motor & resistor on 1999 mazda protege. It worked only on high for the last few months. Which would be the resistor. It stopped working totally the other day, I messed around with it and got to work...

just change the resistor b/c when resistor go bad they get stuck on high or low. selecting on low give you more resistor and less flow of air from the blower and on high side you get less resistor and more flow

good luck

Dec 29, 2008 | 1993 Mazda Protege

Not finding what you are looking for?
1999 Mazda 626 Logo

Related Topics:

313 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides