Wipers wont work on my 2009 Chevrolet Impala LS
SOURCE: NEED TO REPLACE A TAIL LIGHT BULB IN A 2005 CHEVROLET IMPALA
and Repair Notes TAIL LAMP REPLACEMENT REMOVAL PROCEDURE Open the rear compartment. Remove wingnut and pull back the rear compartment trim panel from the tail lamp. Remove the wingnuts from the tail lamp. Remove the tail lamp from the rear body panel. Disconnect the electrical connector from the tail lamp. Remove the tail lamp socket, turning counterclockwise. Remove the bulb from the tail lamp socket. Remove the sidemarker lamp socket, turning counterclockwise. Remove the bulb from the sidemarker lamp socket. INSTALLATION PROCEDURE Install the bulb to the tail lamp socket. Install the bulb to the sidemarker lamp socket. Install the sidemarker lamp socket, turning clockwise. Install the tail lamp socket, turning clockwise. Connect the electrical connector to the tail lamp. Install the tail lamp to the rear body panel. Install the wingnuts to the tail lamp. Pull back the rear compartment trim panel to the tail lamp and install the wingnut. Close the rear compartment.
SOURCE: 2001 Chevrolet Impala Door Locks Suddenly Quit Working
Passenger side of the fender under the hood - check the fuse relay box - about $12.00 a piece - they do go bad from time to time.
exchange the power lock relay with another one and test the locks.
then put the relay back and go to the autostore.
SOURCE: i need a serpentine belt assembly guide or diagram for a 2006 3.5 liter v6 chevrolet impala
Diagram 9-5 on this page:
http://www.daycoproducts.com/daycoweb.nsf/Serp%20Rout%20Guide%20Illus.pdf
SOURCE: 2005 impala ls the abs light and the traction control light comes
You'll need to have the codes read from the computer. You will have a code that indicates one of the front wheel sensors is bad. This could be the case, but they are very expensive as they are built into the wheel bearing assemblies. It is more likely that the wiring harness between the frame and the part of the front spindle that holds the harness, has broken internally. It is a very common problem and can be repaired with a new wiring harness section or by tracking down the fault and repairing it.
SOURCE: 2003 Impala: HOW DO I CHANGE BATTERY 2005 CHEVROLET IMPALA...
The battery is under the hood, just behind the passenger headlight.
There is a black bar that crosses over the battery and goes back towards strut tower. Remove this bar and the three bolts; probably a 12 or 13mm socket.
Remove the negative (black) battery cable with an 8mm socket or wrench. A 5/16" should work also.
Then remove the positive (red) cable with same socket.
Remove the battery clamp and bolt. Probably a 12mm socket with extension.
It's tight, but the battery can be removed.
Reverse instructions for installing the battery. (That includes hooking up the red battery cable first, then the black cable.)
164 views
Usually answered in minutes!
×