Question about 1999 Dodge Durango

Open Question

Codes for 1999 dodge durango 4X4,P0753 shift solenoid A circuit electrical?? and P 1763 manufacturer control transmission ??

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

keemo68
  • 1263 Answers

SOURCE: p0753 shift solenoid a electrical

it's not a difficult fix , however to replace the trans control module and or solenoid is time consumming because tou have to remove a few thing s to get your hands in a tight area but most mechanics already deal with this problem on a daily bases

Posted on May 20, 2009

  • 1 Answer

SOURCE: jeep codes location of unit

Got me a complete manual for 199 jeep factory model and found location of each individual unit in question. Manual gives u possible solution to each code and repair and or replace. As a mechanic myself testing, trouble shooting and repair was not that difficult. Shift solenoid was very difficult to get to. Located under the head lamp passenger side.

Posted on Nov 19, 2008

dennymulford
  • 1055 Answers

SOURCE: 1998 Chevy Cavalier-electical

youve either got a bad connection at the new battery or the power wire is shorting out did he have too pull the cables too get them too fit?

Posted on Feb 27, 2009

  • 23 Answers

SOURCE: I have a 1999 Chevy Blazer. A scan reveals code

i had to replace mine. i went to www.rockauto.com and found them for $15 a piece. its actually really easy to do. drop the pan. at the back toward the driveshaft you will see 2 right next to each other. pop out the c clips and it should come right out. reverse those steps to put it back in.

Posted on Aug 12, 2009

  • 142 Answers

SOURCE: What does code P0753 Shift Solenoid mean?

P0753 means your powertrain computer detects a continuous open, short to ground or short to power in the circuit to your transmission's 1-2 shift solenoid. When the code is active, your transmission runs in a fail safe/limp home mode that only lets certain gear ratios function in the transmission.

The solenoid in your application looks like this
1edc2e6.jpg and it is located sometimes on the side of the transmission, but my guess is from the looks of it, it might be found inside the transmission, only accessible with the oil pan removed.
The problem might be the solenoid itself, or the wiring going to the solenoid from the computer that controls the transmission, or the computer itself.

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy impala 2005 3.4 engine. I have code P0753 it says 1-2 shift solenoid. will flushing transmission fix that problem. where are the shift solenoid on that car


code p0753 refers to shift solenoid(SS) A-electrical===causes--wiring--shift solenoid--ECM/TCM
The fault is electrical as it is a solenoid ( an object that has a coil wound around a core in which a bar of steel is magnetically moved when the coil is energized This bar movement moves valves or locks bands or clutches)
Change the solenoid and check out the transmission control module(TCM).
changing the oil will be good for the transmission but will not fix the electrical fault.

Feb 21, 2015 | 2005 Chevrolet Impala

1 Answer

Remove 4x4 transmission of a dodge durango 4x4


a lot of those dodges have electrical solenoid shift pack assyemblies that cause the vehicle not to shift the kit comes with 4 solenoids and wires

May 12, 2014 | 2001 Dodge Durango

1 Answer

P0753



P0753 - Shift Solenoid A Electrical
- Low transmission fluid level
- Dirty transmission fluid
- Faulty shift solenoid 'A' valve
- Shift solenoid 'A' valve harness or connectors
- Shift solenoid 'A' valve circuit is open or shorted


Read more: http://engine-codes.com/p0753.html#ixzz31EB1WygL


May 07, 2014 | 2001 Lincoln LS

1 Answer

I have to error code with my jeep grand Cherokee Laredo 1999 the code are 1491,1495,753,136


P1491 Rad Fan Control Relay Circuit An open or shorted condition detected in the radiator fan control relay control circuit. This includes PWM solid state relays.P1495 Leak Detection Pump Solenoid Circuit An open or shorted condition detected in the Leak Detection Pump (LDP) solenoid circuit.P0753 (M) Trans 3-4 Shift Sol/Trans Relay Circuits An open or shorted condition detected in the overdrive solenoid control circuit or Trans Relay Circuit in JTEC RE transmissions. Was MIL code 45. P0753 (M) Trans 3-4 Shift Sol/Trans Relay Circuits An open or shorted condition detected in the transmission 2-4 shift solenoid circuit (4-speed auto. trans. only).P0136 (M) 1/2 O2 Sensor Heater Circuit Malfunction Oxygen sensor heater element malfunction.

Aside from getting into an accident and having your wiring harness severely damaged, the other likely suspect is your PCM. These codes are not related to each other and indicate a much larger problem.

Nov 02, 2013 | 1999 Jeep Grand Cherokee

1 Answer

Codes po740, po743 ? po753 all at once. Where should i begin for repairs?


You must do the diagnostics for each code.
Here are the possibilitesP0740 DODGE - Torque Converter Clutch Circuitxicon.jpghttp://engine-codes.com/p0740_dodge.htmlForum CodePossible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
P0743 DODGE - Torque Converter Clutch Solenoid Circuitxicon.jpghttp://engine-codes.com/p0743_dodge.htmlForum CodePossible causes- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid

P0753 DODGEP0753 DODGE - 3-4 Shift Solenoid Relayxicon.jpghttp://engine-codes.com/p0753_dodge.htmlForum CodePossible causes- Faulty shift solenoid valve
- Shift solenoid valve harness or connectors
- Shift solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid

Jul 03, 2012 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Code p0753 for a dodge ram 2500 360 m


Both fault codes refer at Tnasmission problem...

P0743 - Torque Converter Circuit Electrical
This DTC appears when an open or shorted condition is detected in the TCC (Torque Converter Clutch) solenoid control circuit; check this as possible causes:
- fused ignition switch output circuit open
- torque converter clutch solenoid defective
- TCC solenoid circuit w/h intermittent defect
- TCCsolenoid circuit w/h observable defect
- TCC solenoid control circuit open
- TCC solenoid control circuit short to ground
- PCM defective (TCC solenoid control circuit)

You will need remove the cover/pan to inspect the harness that goes to all the solonoids and then to inspect the valvebody and the TCC solonoid itself. If you have a multimeter then you could ohm through the harness and even the solonoid. I have found that most of the time this code was produced because of the solonoid itself. But it could be the circuits to it also. There is abig connector an top of the trans that goes into the trans and the internal harness ispect that connector for any corrosion or damaged pins or wires.


P0753 - Shift Solenoid A Electrical Malfunction
This is a common repair that I have replaced several of the solenoid but it is not a cronic problem. It be the wire going to the solenoid shorted so make sure that is check before the transmission is tilted down and the side cover removed. 90% it is just the solenoid; the solenoid is located in the side pan of the tranmission. It would mean lowering the cradle(what the engine and transmission sit on) and lowering the transmission down about one to two feet. Check this like a possible cause:
- 1-2 shift solenoid control circuit is open or shorted to ground
- 1-2 shift solenoid control circuit is shorted to voltage
- 1-2 shift solenoid has failed
- PCM has failed

You will need to remove the transmission pan and its the solenoid with the red and light green wires going to it. Let us know if you have questions contact us here.

Hope this helps and just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer. Thank you for using FixYa.

Jose.






Oct 20, 2011 | 1997 Dodge Ram 2500 Club Cab

1 Answer

Coud p0753 durango 1998


DTC P0753 is for the 3-4 shift solenoid in the trans.
This is an electrical code, it will set when the voltage seen by the engine controller on the solenoid's control circuit is incorrect. The solenoid pack gets a constant 12v from the trans relay and is controlled by the engine controller by switching ground.

Since you don't have a code for the TCC solenoid that shares the same relay feed and you don't have a trans relay code set we know the problem is isolated to the solenoid or it's control wire. It could be a short, broken wire, or corrosion in the control wire between the trans and engine controller, but this is almost always the solenoid itself.

This code is not not saying replace parts. They say check it out on yours a code 753 points to a 3-4 shift solenoid relay problem or wiring problem. Other thing to check could be the speed sensor module that screws into the side of the transfer case. back feeding bad info to ECM.

zjlimited_1910.jpg

Hope helps.

Sep 22, 2011 | Dodge Durango Cars & Trucks

1 Answer

My 2000 dodge durango v8 5.9L is getting 3 error code 0443, 0753, 1753 how to fix?


P0443 EVAP Purge Solenoid Circuit Malfunction Check your gas cap make sure that it is on tight, or just replace roughly 7 dollars.

P0753 3-4 Solenoid/Transmission Relay Circuit Malfunction - With Automatic Transmission I would try clearing the codes and seeing if this one comes back on. If it does then you need the Transmission Relay, it is located in the engine compartment.

1753 is your transmission lockup solenoid is bad. I would replace this solenoid and it will most likely clear the code for the P0753 or since you are going to be in there you can just replace both.

Everything is at your local parts store, they might have to order it but that will take 1 day

Jun 16, 2011 | 2000 Dodge Durango

2 Answers

P0753 car want go into ovr drive and has high rpm


This code means theres a problem with the shift soleniod for the 3-4 shift, have this soleniod tested,its locted on the valvebody if the pan was dropped you will see the soleniod.

Oct 04, 2010 | 2000 Dodge Durango

3 Answers

Transmission code PO753, how to repair?


PO753 code on a Durango can also be caused by a bad transmision relay in the relay -fuse block behind the battery in the engine compartment. (relay # 31 on 1999 Durango) Before you attempt to replace the 3-4 solenoid, or take to a transmission shop, try changing the relay out with another known good relay, reset the code and try it. I learned this today from an honest transmission shop. Shifts normally again, check engine light is out, and the shop did not charge me a dime. Kudos to Trans Medic in Gresham OR.

Mar 26, 2009 | 2000 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

483 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...