Question about 2005 Dodge Neon

1 Answer

I have 2005 neon sxt keep having code po457 evap emmission loose cap /off replaced cap from chrysler ck eng light comes back on same code anybody have any suggestions

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,959 Answers

Fuel cap is just one of the causes. Here are 2 others:

  • possible vacuum leak
  • NVLD switch is stuck or malfunctioning
NVLD switch communicates with your car's computer. A bad switch will throw a P0457 error code. Check for a vacuum leak 1st but if none is found, the NVLD switch should be changed.
Below is a link that explains more thoroughly what the module does; I do wish you the best of luck with your Neon and hope you found this information helpful. Take care!
http://www.search-autoparts.com/searchautoparts/article/articleDetail.jsp?id=377511&sk=&date=&pageID=3

Posted on May 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 jeep liberty 3.7 code # po457 # po456 exhaust leak.


457 is loose gas cap
page 9-2 in the service manual.
456 is EVAP leak, small,. saMe loose cap
this is like the #1 failure off every car here from 1996 to now.
loss cap.
reset the DTC using scan tool
put the cap tight, and drive.
if comes back then cap is bad.
if still comes back the tank venting system does leak.
for sure there is a leak only WHAT is not known
in a shop they do leak down test , if pass , the cap was bad. or loose.

Jan 12, 2017 | 2007 Jeep Liberty

2 Answers

Po455


Check all hoses and fittings from evap back to fuel tank. On 1post in pacifica world the prob was solved by dropping the fuel tank and replacing the fitting on one of the fuel pumps. Then clear the code and hopefully doesn't come back.

Sep 08, 2014 | 2005 Chrysler Pacifica

1 Answer

Why is my 2005 dodge neon sxt automatic significantly jerking at 60 mph?


You have an intermittent problem, and it's probably going to be horribly difficult to track down. Your best bet might be to borrow an OBDII scan tool so you can read the codes while the problem is happening.

That mechanic who visually inspected your camshaft position sensor apparently doesn't understand that the sensor can LOOK just FINE while at the same time it's as dead as a doornail. You might try having that one sensor replaced, just to be sure.

Aug 04, 2014 | 2005 Dodge Neon SXT

2 Answers

I have a Dodge Ram F1500 engine light came on code is po456 and po457 were can I find out what that is so I can fix the problem


po456 evaporative control small leak

p0457 EVAP System Leak Detected/Fuel Fill Cap Loose Or Missing

Sep 07, 2013 | Dodge Ram 1500 Cars & Trucks

1 Answer

Put a K&N Performance Cold Air intake into my 2005 Dodge Neon SXT, 0441 code comes up?


Hi there:
DTC P0441 - Evap. Emission System Incorrect Purge Flow
Possible causes: poor/loose connection, faulty purge control solenoid valve (PCSV), faulty PCM.

Check for loose electrical connector and for loose or broke vacuum hose to it. If ok, you will need a voltmeter and vacuum gauge to test it. If fails test, replace it, if ok, then likely a faulty pcm. Most of the time it is either a bad vacuum hose to it or faulty PCSV.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 21, 2012 | 2005 Dodge Neon SXT

1 Answer

2003 town&country ck eng light on


p0455 is for evap leaks check hose on the passenger side by the fender under the hood a hose coming from the engine to the purge control valve one of the rubber hose is probably broken

Sep 23, 2009 | 2003 Chrysler Town & Country

1 Answer

2006 Dodge Stratus Check engine light


Small vacuum leak to start in evap system, which can quite often be traced back to gas cap. I'd clean gas cap seal good & add a little Vaseline, to the rubber "O" ring on cap, and wipe surface where cap screws in real good & clean, then have codes erased, or disconnect battery for a few seconds, and then see if it comes back. Make sure you put cap on tight after adding fuel.

Aug 30, 2009 | 2006 Dodge Stratus

1 Answer

2005 pt cruiser check engine light came on put a diagnostic code tester on and it came up code po457 and po456 what would this mean?


P0457 is a loose gas cap, P0456 is a small evap system leak. The seal on your gas cap is probably worn. Replace the cap, clear the codes with either a diagnostic tester or by disconnecting the battery for a few minutes and reconnecting it. It will take a few days for the code to come back if it isn't fixed, but that usually does the trick. I hope this helps.

Apr 27, 2009 | 2005 Chrysler PT Cruiser

1 Answer

2006 caravan odomiter says gas cap


On the gas cap itself theres a rubber o-ring.If thats quashed in any way you'll need to replace it.Sometimes takink the o-ring off and putting it back on fixes the problem.Its a very common problem ans is not that expensive to fix..The reason the code keeps coming back is because its a pressurize system and if theres a leak in the system it will throw the light in the dash..

Mar 30, 2009 | 2006 Dodge Caravan

2 Answers

2002 chrysler neon error code p0456


a small evap leak is often interpreted as a loose gas cap , which it can be , it means the evap systems integrity has been breached , it can be an electrical solenoid , switch or just a vacuum line in the system . a bidirectional scanner can run the evap test after checking the gas cap , most well equipped shops can hook up a smoke machine to the evap system service port and run the smoke test , it there is a leak you will see the smoke , makes the diagnosis quickly . get an estimate from a reputable shop , by the way this problem has no effect on drivability , but should be fixed . cheers

Jan 13, 2009 | 2003 Dodge Neon

Not finding what you are looking for?
2005 Dodge Neon Logo

Related Topics:

923 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...