Question about Mazda B2600

1 Answer

It will start, runs for a while then dies it has no spark to the spark plugs and will not start again for at least 2-3 hours

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 334 Answers

Check your coil .when a coil get hot it will not work.

Posted on May 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 1985 Nissan truck turns on and drives for about 1 hour then it dies, I have to wait another day then it will drive again, what can be wrong


How many miles do you have on her,I also have a 85 Nissan 720 4x4.hAD HER FOR 22 YEARS,IN MINT CONDITION,

Jan 08, 2016 | 1985 Nissan Pickup

1 Answer

Car starts and dies


Clean is required in the carburetor as well as this could also be due to water content in the fuel tank. Spark plug cleaning will also help.

Aug 22, 2014 | 2009 Toyota Matrix

1 Answer

My 1995 jeep will die just driving and sometimes will start right back up other times you have to wait about an hour. fuel pump is working fine you can hear it


The pump can be running but not pumping any fuel.
When it stops running you will need to figure out if you are loosing spark to the plugs or fuel to the injectors.

Jul 27, 2014 | 1995 Jeep Grand Cherokee

1 Answer

MY 1989 FORD BRONCO WILL START UP RUN FOR ABOUT 15 MIN THEN IT DIES IF YOU WAIT ABOUT A HOUR IT WILL START BACK BUT DOSE THE SAME THING


Have you figured out if you are lacking fuel or spark when it fails to start back up ? Lack of fuel could be a pump relay, lack of spark could be the ignition module or the EEC relay.

Feb 24, 2014 | 1989 Ford F 150

2 Answers

Car starts right up but 2 seconds dies, u can start it right up again & it dies again, won't run. has good spark & fuel pressure good when dies


You are on the right track by finding the injector pulse missing.
The computer grounds the injectors based on signals from the cam and crank sensors. You may have to use a scanner to check for trouble codes in the computer and watch the sensors work.
The problem could also be a relay or the key switch.

Dec 10, 2012 | Cars & Trucks

1 Answer

My car shuts down randomly, and sometimes will start, shake voilently and then die again, sometimes starts right back up, other times takes over an hour to run again.


1) you must pass the Scanner +computer you will have a exactly diagnostic.
2) However you must reset the ignition timing to the manufacturer specification, Does not matter if your Electronic Ignition(EI)
3) TEST the coil ignition for defective.
4) cables spark plug for open or faulty
5) spark plug for defective.
6) EI module for defective.
God bless you

Oct 05, 2012 | 1994 Mazda Navajo

1 Answer

My mazda protege died in middle of driving. i changed the fuel pump, it drove properly for less than an hour. then it started loosing power where it would go up and down in speed. over the course of 3...


Probably your spark plug get wet (water get into your spark plug), so it doesn't work quite well to give high voltage spark to burn fuel.
Clean your spark plug by removing spark plugs of 4 cylinders and clean, start engine to blow out the residue water in spark plug socket. And install spark plug into 4 cylinders

Aug 19, 2009 | 2000 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...