Question about Chevrolet Impala

1 Answer

Just replaced steering colum and the brake lights are stuck on now

My brake lights are stuck on, its a 03 chevy impala

Posted by on

  • Thomas F. Schneider May 11, 2010

    Replace or lub the brake light switch located above the brake lever.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 710 Answers

GOOD CALL SMITHBROTHER, THAT'S WHAT I WOULD HAVE CHECKED AT FIRST. IT MAY BE OUT OF ADJUSTMENT. SEE IF IT WILL PIVOT TO THE POINT OF FUNCTIONING CORRECTLY. IF IT WON'T ADJUST THEN REPLACE IT LIKE SMITHBROTHER SAYS. HOPE THIS HELPS. THANKS FOR AN HONEST RATING FOR BOTH OF US, AND FOR USING FIX-YA.

Posted on May 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is brake light flasher for 1997 Chevy Monte Carlo located?


Signal light and emergency flashers are usually installed under dash near steering colum, or in the fuse boxs.....Hope that helps...

Mar 02, 2015 | Chevrolet Cars & Trucks

1 Answer

Why don't my brake lights and hazard lights work on my 93 chevy 1500 4x4


more than likely its the multi-function switch that is the problem...(on the steering colum)

Feb 20, 2014 | 1993 Chevrolet K1500

1 Answer

My 1990 Chevy C1500 has no lighting on the inside or to the tail lights/brake lights.


With a test light check if you have power to the turn signal switch located on the steering colume under the dash if it checks out you have power replace turn sinal switch

Jun 29, 2011 | 1990 Chevrolet C1500

1 Answer

What could cause brake lights to work every now and then


I would check your brake light swich located under dash just fallow your brake pedle with a test light see if you have power going to it slitely press brake pedle see if other side of switch has power (key on car not running) if not try ajusting it by pulling on it or unscewing it if all checks out ok replace turn signal switch disconnect battery remove center part of steerring remove center bolt with steerring puller pull steering wheel with locking plate puller pull locking plate remove turn signal handle emergency button three scews holding turn signal under dash fallow steering colum disconect wires on right side (passenger side) tape a long wire to end of connector pull turn signal without pulling tape wire all the way out so you can tape it to new turn signal wire connector to be able to pull wires back down steerring colume (you might have to losen steerring colume and bracket two scews under dash four on steering colume)

Jun 27, 2011 | 1998 Dodge Ram 3500 2WD

2 Answers

Back break lights wont engage when you press on brakes


It could be the break light switch, but the more likely culprit is that you need new bulbs. I'd head down to the local parts store.

Hope this help.

Feb 18, 2011 | 1998 Plymouth Voyager

1 Answer

Steering colume replace signal light handle


what are you replacing, your question is cut off.

Sep 29, 2009 | 2002 Chevrolet Impala

1 Answer

All three brake lights don't work


it was the brake hazzard ligt switch in the steering colum

Feb 08, 2009 | 1998 Chevrolet Lumina

1 Answer

2003 chevy blazer


THAT PIECE HAS TO BE REPLACED UNDER THE DASH,I CAME ACROSS THAT PROBLEM BEFORE. I FORGOT THE NAME OF IT .THAT PART PREVENTS YOU FROM PUTTING IT IN GEAR WITHOUT PRESSING THE BRAKE.(SAFTEY DEVICE) ITS ON THE STERING COLUME

Oct 17, 2008 | 2003 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...