Can not find location of fasher unit on a hyundia/tiburon2003 ...need to replace the flasher cant found the installation dont know the spot of the old flasher location...need a response asap..

The flasher unit on a Toyota Land Cruiser HZJ75 is usually located in the fuse box under the dashboard on the driver's side of the vehicle. To access the flasher unit, you will need to:

1. Open the driver's side door and locate the fuse box cover. It is usually located under the dashboard on the left side of the steering wheel.
2. Remove the fuse box cover: Depending on the model of your Land Cruiser, you may need to use a tool like a flat-head screwdriver to gently pry the cover off.
3. Locate the flasher unit: Once the cover is removed, you should be able to see the various fuses and relays in the fuse box. The flasher unit is usually labeled as "flasher" or "turn signal relay." It may be a small, rectangular component with wires or terminals attached to it.
4. Remove the flasher unit: Depending on the model of your Land Cruiser, you may need to use a tool like a socket wrench or pliers to remove the flasher unit. Some models may have a clip or tab that holds the flasher unit in place, which you will need to release before removing it.
5. Replace the flasher unit: Reverse the steps above to install the new flasher unit. Make sure the new unit is securely fastened and all the wires and connectors are properly connected.

If you are not comfortable or experienced in automotive repairs, it is recommended to have a mechanic perform the flasher unit replacement.

"Need to know where the flasher location is on a 99 Ford Contour"

It is located or plugged into the side of the multi-function switch. If you remove the plastic covers from the steering column you will be able to replace the flasher.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

need to replace signal flasher unit..cheap fix.located usually under steering colum or around fuse box. If you dont know what it looks like ,go to parts store and see what it looks like. usually small and round..it will be easier to locate.if no fix then you will need turn switch. sometimes you can tap the flasher unit and it may work a couple of times it

FLASHER
The flasher unit is located behind the lefthand side of the instrument panel, behind the instrument cluster.

hello. The problem could be the flasher or it could be the fuse. Drive to an autozone or other parts store and ask them to help you locate the flasher and the fuse panel. They will quickly determine what needs to be changed and help you do it..... a free courtesy service.

The flashers are located behind the instrument panel trim, roughly between the base of the steering wheel and the ashtray, just to the left of the car lighter. To access the flashers, you need to at least loosen the lower instrument panel trim. Just under the steering column there are two screws with star heads. One to the left of the column and one to the right. You need to remove both of these screws. You will need to remove your ashtray. On the upper left corner of the hole left by removing the ashtray is a 9/32 hex head screw. You need to remove it. Once these three screws are removed you should be able to pull down on this portion of trim under your instrument cluster. When you do this it may cause trim around your instrument cluster to loosen that you can just pop back into place with your hand. You won't need to pull down to far on this trim piece as there are still some screws holding the bottom. You should be able to pull it down far enough to see the flasher units behind and just to the left of the cigarette lighter. There are two flasher units and I found that the one on the right is for the turn signals.On the left the other is for the hazard flashers. It may be a hand scraping experience to replace the flasher but it beats paying someone to do it for you. They are easy to recognize because the are silver and round metallic plug ins. The flasher unit on the left is for the emergency flashers and the one on the right is for turn signals. You can place the emergency flasher unit into the slot the turn signal unit belongs until you get a replacement. These flasher units are pretty cheap.

there are many plugs that are not connected, they fit onto accessories you may not have, how would it get disconnected? did they work before? f so the plug is not the problem and the turn siganl flasher module is, replace the flasher.

Looks like the flasher relay is in the hazard switch assembly. A couple of tabs hold the prettry faux wood decorative plate in. You edge these out from underneath with a couple of small screwdrivers. I found it easier to remove the radio/CD unit (but remember you need the 4-digit code to re-enliven it). My plate shot off along with the switch covers and ashtray cover. (I think I've found most of them). Next you edge out the hazard switch assembly from its bottom. The cheapest place to get a new $30 assembly was accessoriesgiant.com (probably made in Mexico, along with the $60 OEM part).

The fuse should be in the fusebox, either under the hood or maybe inside the glovebox (I've seen it there on a 1990 Grand Prix). It could also be on the underside of the dash on the driver's side. If the fuse itself is fine, it's probably the hazard relay. Often this is built into the hazard button, and the relay controls both the hazards and the turn signals.

The unit is located to the left of the steering column just above the Body Control Module.