SOURCE: blower for Heat/A/c not working
Blower Motor Resistor Replacement
Removal Procedure
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
Tighten the screws to 1.6 N·m (14 lb in).
SOURCE: where do i find engine serial number for a chevy caprice motor
if you have the engine out itheir is a vin num stamped on the rear of the heads ,olso if its a small block shuch as a 350 327 305 or even the 400 small block90% of the engine parts are enter changeable,
their shoulf also be a vin number stamped on the block right above the top bolt of the water pump on the drivers side
SOURCE: 2003 Chevy Malibou RU872 resistor location blower switch relay
For location and replacement of the BMR. Remove the shroud below the glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the power harness - - you'll need this extra room to work with. 2 more screws, same size, 7/32, 6.5, 7or 8mm on some, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage/dealer - up to $400.
SOURCE: fuel pump relay location 1990 chevy subburn
One of the easiest ways is to listen for pump to cycle in tank "HUM" when someone cycles key to on. If you hear "Hum" pump is getting power. The other would be to swap it out with another in that area, with same # on it. Under hood, passenger side, on firewall usually. Should be at least one more relay there with same #. There are so many ways that manufacturers recommend for different vehicles, this is usually the easiest. If I can't test for power in & out of relay when key on, I'll go direct to tank sender & check for power there to be sure.
SOURCE: 2002 Chevy Impala Blower resistor location
It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike
243 views
Usually answered in minutes!
×