Question about 1995 Mazda 626

1 Answer

1995 mazda 626, won't start i put it in park and it acts like its still in reverse and rolls back, also the gears read that it is in park and reverse what do i do

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 5,568 Answers

This sounds like a linkage adjustment that has slipped with time; shouldn't be costly to cure and because of the potential hazard, I hope your parking brake is good.
If you aren't a DIYer, check your local BBB pages to find an honest transmission shop so they don't 'fix' something that isn't broken.  

Posted on May 10, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The car worked fine, then when parking, I tried to put car in reverse, and nothing happened. I tried again and it lurched into drive, stopped and now will not go anywhere, not even roll. Reviewed the...


Did you notice if your speedometer quit working at the same time? If so, there is a glimmer of hope, it may be a vehicle speed sensor problem. Otherwise, it sounds like the trans just took a dump. Try shifting the trans into ALL gears (including 2 and 1) to see if that makes a difference.

Aug 21, 2011 | 2000 Mazda 626

1 Answer

Pulled into parking spot, did not put into PARK but had foot on brake while reaching for wallet. Felt like the car was rolling a bit. Looked up but wasn't certain I had rolled. Put it in PARK and felt...


This is a tranmission linkage problem. The car may be in park but the linkage arm well sometimes slip of or sometimes just run crooked as you switch through the gears. My car has also done the same thing until I recapped the arm with a new lock washer

Sep 12, 2010 | 2000 Mazda 626

1 Answer

Engine works, but my car won't move when I give it gas.


Could be your clutch or the cable from the shifter has a plastic piece that is easily broken that wont allow proper gear placement

Jul 28, 2010 | 2004 Mazda 6

1 Answer

My car stopped starting.


Based on the information you have supplied, the car is not shifting in to the correct position. So when you try starting the car , it will not allow the starter to crank thinking it is not in park (which it is not...in reverse) I suspect that the shifter cable from lever to the transmission has become stretched over time and use. It can be adjusted at the transmission to shift cable hook up. The connection at the lever base could have also get disconnected. Try that first

May 03, 2010 | 1997 Mazda 626

2 Answers

My car would not go forward when I put it into drive it rolls bac


Could be the shift cable. Mine broke off a while back and it would not shift into any gear. AAMCO was going to charge me $150 to fix it, but I fixed it myself. The connection at the transmission is on the drivers side of the transmission right below and to the rear of the air filter housing. I would guess it could be stuck in neutral for some reason (maybe last gear it passed through before it broke) but mine was stuck in park. It may not be the problem, but it's a simple solution that's worth looking into.

Mar 27, 2010 | 2001 Mazda 626

1 Answer

95 mazda 626 automatic transmition....will not reverse


Check you transmission fluid level and if it's not your transmission, I'm thinking that your brake shoe lineing in the rear brakes may have separated and is jamming up aginst the drums when your trying to back up. Sorry can't halp you with any more, good luck and start with that and hope it help's.

Apr 08, 2009 | 1995 Mazda 626

1 Answer

2001 mazda 626


broke drive axle?..any clicking or clunks associated with this happening?

Jul 01, 2008 | 2001 Mazda 626

Not finding what you are looking for?
1995 Mazda 626 Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...