Question about 1993 Mazda MX-6

3 Answers

1993 mazda mx6 transmission is not slipping, but will not shift into higher gears. Will run at high RPM's and not shift up. Any suggestions on what it might be.. Mechanical, electrical, fluid change,

1993 mazda mx6 transmission is not slipping, but will not shift into higher gears. Will run at high RPM's and not shift up. Any suggestions on what it might be.. Mechanical, electrical, fluid change, etc??

Posted by on

  • 2 more comments 
  • clang089 May 14, 2009

    I just bought the car i changed the trans fluid but it will rev up and just not shift unless i pat the gas? how much is this gonna cost me is wat i wanna know

  • marknthedark
    marknthedark Sep 15, 2012

    i have a 93 mx6 bought it about 6mo ago for 500. seems like all ive done is work on it, dont get me wrong its a go getter.. made for the road.. anyway, my problem now is i need to find the fuel safety switch. any ideas where it may be. was told it was in trunk, or under kick panel i know what it looks like.. Oreillys employee. but just not looking in the right place i guess. oh and thanks to shootguy08 for the input on the trans shift solenoid. It started that about 2 wks ago, seems like it only does it in the mornings. 1st thot it was rear main seal leakn oil on clutch. high rms no go anywhere, its a good thing i didnt pull out in front of anyone..... A buttpucker..lol.

  • marknthedark
    marknthedark Sep 16, 2012

    shift solenoid in a manual trans mission, is that fixible? i work at oreilly's and there are no products found for my info..

  • marknthedark
    marknthedark Sep 16, 2012

    i appreciate all the info you guys give!!

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Sounds like a shift solenoid in the trans.

Posted on May 10, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Heater core in 2005 dodge 2500 5.9 des. how hard is that to change out? any info would be helpful thx.

Posted on Sep 22, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My car wud not change from 1st gear to any other gear.what cud be my problem

Posted on Apr 06, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

At what RPM 1st gear should shift on a H2 Hummer 2003


well is that hummer that a 2 ton or 4 ton vehicle ?

would take a lot of revs for first gear to make it roll from a standing start
think it will be fitted with an 6 speed automatic transmission

guessing only from my heavy vehicle driving experiences
first should change below 3000 rpm

if transmission was slipping in first gear you would know

suggestion
ring up the local hummer service division for the correct answer





26308702-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Oct 12, 2016 | 2003 Hummer H2

1 Answer

My transmission is slipping


The clutch lining worn out n the lining powder stuck on the transmission filter so transmission fluid pass through the filter clogged.. Only way is to repair the transmission or replace the whole transmission.

Nov 27, 2012 | Cars & Trucks

1 Answer

How does the power/econo button work on a 1993 mvp mazda van


The transmission select button varies the shift points , eg; when in 'econo' the trans will shift sooner than when in 'power' mode.
'power' will be to keep the transmission in a higher gear (engine RPMs higher = more power ).

Sep 28, 2011 | 1993 Mazda MPV

1 Answer

Changed the transmission fluid in a 1993 Mazda MX6 (put in 2 1/2 qts) and now it won't shift. What could this be?


make sure you did not disturb wires in transmission maybe you knocked a wire off when doing it check wiring

Feb 01, 2011 | 1993 Mazda MX-6

2 Answers

Slow pick-up, high rpm


It seems as though the Transmission clutches are slipping if it's an automatic or the clutch is worn if it's a standard. If it's an automatic transmission check the Transmission oil it should be clean and no burnt smell. You will easily recognize burnt oil by it's nasty smell.

Jul 03, 2009 | 1996 Hyundai Accent

1 Answer

Transmission 1993 mazda mx6


did you replace the engine? if so, you should check you reinstalled the shift links correctly with the correct bushes.

Jun 18, 2009 | 1993 Mazda MX-6

1 Answer

Car will not go into the last gear


Sounds like something is wrong with your overdrive, is your hold light flashing?

May 26, 2009 | 1993 Mazda MX-6

1 Answer

1995 tahoe auto trans


Sounds like you may have smoked high gear clutches. Check your fluid and see if the color is darker than normal and smells burnt...

Mar 27, 2009 | 1995 Chevrolet Tahoe

Not finding what you are looking for?
1993 Mazda MX-6 Logo

1,522 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...