Heater running normally. Prior to water pump replacement temp gauge inside held between the mark below half and the half mark. Now it goes up to 3/4 and stays. Did not drive it more than a few miles when the gauge went up.
SOURCE: 1996 eagle vision over heating
look for leaks on the passenger side!!!! also this car has a "air pocket" you need to find the bleed off screw on the upper hose fitting on the engine and bleed it when filling up with coolant
SOURCE: 1992 Eagle Talon TSI Fuel Pump not coming on like normal
the book just told me the fuel pump relay is near the ecm under the center console and to test it put the positive to terminal 10 and negative to terminal 8 and with power to the relay connect the negative probe of a voltmeter to the battery negative terminal (where the - is to the relay) and connect the positive to terminal 4 then 5 it should read out about 12 volts at each terminal, connect the jumper leads terminal 9 to battery (+) and terminal 6 to the battery (-) and with those relays connected to the relay check for continuity between terminals 3 and 2 there should be continuity remove the ground from terminal 6 the ohmmeter should read now read no continuity install jumper lead to terminal 3 to battery (+) and terminal 7 to battery (-) check for voltage at terminal 2 and battery (-) should be about 12 volts remove (-) from terminal 7 now should read nothing if anything doesn't read out what i said replace it and the numbers for he terminals start from the plug part you had to push on to remove the wires it goes 1-5 on the top and the bottom 1-6 and this would be with the clip on top if this did not help let me know i will read off the next part to check
158 views
Usually answered in minutes!
×