Question about 2001 Volvo V70

3 Answers

Volvo V7 '01 sunroof will not stop in closed position

The sunroof on my '01 V70 will open however when closing it continues past the closed position and proceeds to open in the ventilation position, then stops there. I have to play with the open/close directions to get it to close. The open close of the ventilation feature do not function at all.

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

REPLACE THE SUNROOF C0NTROL MODULE AND CALIBRATE
THE SUNROOF BY HOLDING THE SWITCH OPEN VENT FOR APPROX. 5 SECONDS. THEN PRESS THE SWITCH TO CLOSE
SUNROOF. THEN PRESS SWITCH TO OPEN SUNROOF.

Posted on May 11, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The above doesn't appear to work. the motor when disengaged doesn't auto-stop.

Posted on Jul 03, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I think I know the answer....your gear has slipped on the cable a few teeth. Set the roof to the desired closed position, flush with your roof. Then open the panel above the mirror by first prying off the switch plate and removing the two 10mm bolts holding the mirror. Remove the sunroof motor gear, or rather just lower it out so it is disengaged with the cables. Now connect the switch and hit the auto open button as if you wanted to open the roof with single flick of the switch. Now hit the auto close button (same button of course, but the single touch method). The motor will advance and stop to where it thinks the roof should be, closed, which it is. Reassemble the gear into the slot, test it if all good, replace the mirror and panel.
Good luck.
Manfred.

Posted on May 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sunroof does not open. Fuse is ok and the shade operates normally.


Do you know how to do automotive electrical testing ?????? How to read a wiring diagrams ???? http://www.bbbind.com/free_tsb.html .Videos on youtube Ohms Law Tech Tip from L1 with Dave Hobbs Copy of Voltage Drop Essentials TST Motor Age The only way to find the problem , testing !

Sunroof Description and Operation (One Connector System)
Sunroof
This diagnostic procedure is to be used for the 1 connector Sunroof System that combines the sunroof control module with the sunroof motor/actuator.
The Sunroof System consists of the following components:
• BATT MAIN 2 Fuse 50 A
• Body control module (BCM)
• RAP relay
• S/Roof Fuse 20 A
• Sunroof module (includes sunroof motor/actuator)
• Sunroof switch
The Sunroof System is controlled by the sunroof switch and the sunroof motor/actuator assembly.
When the ignition is turned to RUN or ACCESSORY, or when the retained accessory power (RAP) system is active, the body control module (BCM) applies a ground to the RAP relay in the instrument panel (I/P) fuse block. This activates the RAP relay and allows battery positive voltage to be applied through the SUNROOF Fuse to the sunroof module. Ground for the sunroof module is supplied from G302.
The sunroof can be placed in 3 preset positions:
• Open
• Vent
• Closed
When the sunroof switch is placed in the OPEN position, a ground is applied from the sunroof switch low reference circuit , through the sunroof switch and to the sunroof switch open signal circuit. The sunroof motor/actuator then applies voltage to the sunroof motor open control circuit and applies a ground to the sunroof motor close circuit. The sunroof motor then opens the sunroof to the full open position.
When the sunroof switch is placed in the VENT position, a ground is applied from the sunroof switch low reference circuit , through the sunroof switch and to the sunroof switch open signal circuit. The sunroof module then applies voltage to the sunroof motor open control circuit and applies a ground to the sunroof motor close circuit. The sunroof motor then opens the sunroof to the VENT position.
When the sunroof switch is placed and held in the CLOSED position, a ground is applied from the sunroof switch low reference circuit , through the sunroof switch and to the sunroof switch close signal circuit. The sunroof module then applies voltage to the sunroof motor close control circuit and applies a ground to the sunroof motor open circuit. The sunroof motor then closes the sunroof.
The sunroof can be placed in any preferred open position when:
• The sunroof is in the fully opened position by pressing and holding the sunroof switch in the CLOSE position until the panel has reached the desired position then release the CLOSE switch in order to stop the sunroof
• The sunroof is opening, it can be stopped by momentarily pressing either side of the switch.
The sunroof control module, sun roof actuator, and the sunroof motor are integral parts of the sunroof module assembly and are not service separately.

Your best bet , take it to a qualified repair shop or buick dealer .

Feb 10, 2017 | 2010 Buick LaCrosse CXS

1 Answer

WHERE CAN I DOWNLOAD A 2004 CADILLAC CTS REPAIR MANUEL?


Here's a description the sun roof
Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof module
• Sunroof switch
• Sunroof motor, with 2 hall effect sensors and limit switch
• Sunroof window
• Sunroof sunshade panel
• Power supply for the sunroof module: RAP 25 A
• Ground G402

Override
The override function is used when needing to force a closing of the sunroof window. To override the system:
Turn ignition to ON.
Rotate the sunroof switch to the close position.
Press upward.
The sunroof switch data 6 circuit, or override circuit, will become grounded at the sunroof module. As long as the sunroof module sees this input, it will continue to slide the sunroof window to close, regardless of the other sunroof switch data circuits inputs.

Oct 28, 2016 | Cadillac Cars & Trucks

1 Answer

2004 Volvo V70 - can't close the rear passenger door - seems like the latch won't move out of the way to close the door - the latch is in the down position. Tried locking and unlocking - tried the child...


I HAVE A Volvo v70 2005 Everything is dead on the passenger door. no centre lock or window actuvation. The bad part I cannot open the door ( I think when there is no electric to the door the ded bolt keeps the door locked. How to get the door open so I can take the trim panel off to see why there a problem

Feb 18, 2011 | 2004 Volvo V70

1 Answer

Moonroof wont close all the way


Do you know how to test automotive electrical circuit's with a DVOM - digital volt ohm meter ? When adjusting the moon roof did you see any switches ? sunroof limit switch
Measure the reference voltage of the sunroof limit switch soft stop signal circuit at the sunroof control harness connector to a good ground.
Does the reference voltage measure near the specified value?
4.5-5.5 V
Notice: Do not open the sunroof glass past the full open soft stop position. Doing so may damage the sunroof assembly and or the roof top.
Connect a jumper wire to the sunroof limit switch soft stop signal circuit at the sunroof control module harness to a good ground.
Turn ON the ignition, with the engine OFF.
Using the sunroof switch, operate the sunroof system, not to exceed the full open soft stop position.
Does the system operate as requested?

Do you know what a wiring diagram is ? Free one's here
http://www.bbbind.com/free_tsb.html Enter vehicle info. year ,make ,model an engine size . Under system click body & accessories ,then under subsystem click on sun roof . Click the search button then the blue link . See the control module , motor an the two switches ? One is probably miss adjusted . or bad !

Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof control module
• Sunroof motor with the limit switches
• Sunroof switch
• Sunroof glass-spoiler type, with glass sliding above roof
• Sunshade
• Rail and track assembly upon which the sunroof glass rides
• Power sunroof system circuit breaker: PWR WDO 25 A
• Ground: G204

Sunroof Limit Switches
The sunroof limit switches track the position of the sunroof glass through two limit switches:
• Soft Stop limit switch through the sunroof limit switch soft stop signal circuit
• Vent Stop limit switch through the sunroof limit switch range signal circuit
The sunroof control module monitors the limit switches and based on the input combinations, determines the position of the sunroof glass. As a sunroof limit switch closes, the 5 volt reference will be shorted to the sunroof limit switch low reference circuit, pulling the 5 volt reference to 0 volts.
The sunroof control module monitors both sunroof switch input requests and based on the sunroof limit switch input combinations, will control an output to the sunroof motor, to drive the sunroof glass to the requested position.

Sunroof Motor
The sunroof has a bi-directional motor. When the motor is not operating both circuits are grounded. When the motor drives the sunroof glass in the direction from the closed to vent or vent to open position, the following occurs:
• Voltage is supplied to the sunroof motor open circuit.
• Ground is maintained to the sunroof motor close circuit.
When the motor drives the sunroof in the direction from the open to vent or vent to closed position, the following occurs:
• Voltage is supplied to the sunroof motor close circuit.
• Ground is maintained to the sunroof motor open circuit.
The sunroof control module is equipped with a timer circuit which stops the operation of the sunroof motor after 8 seconds.

Dec 23, 2017 | 2003 Pontiac Sunfire

1 Answer

Have '01 v70. Sunroof opened all the way, now won't close. I've pulled the light assembly/cover to get a look at it. The black plastic electronic box seems to have some sort of sensing ability to it that...


there should be a slot you can put a flat head screwdriver in to turn the motor round and close the roof. the motor assembly there is a magnet inside and a reader to tell the motor when to stop or move. the sensor can fail and ope till it cannot move any more it also as a water trigger. this in the event that the vehicle is under water the sunroof opens so you can get out. this feature can go wrong a well.

Jun 15, 2017 | 2001 Volvo V70

1 Answer

2001 Volvo V70 with sun roof...car sitting in heavy rain..return to car both front drivers side and passenger side footwells were full of water. What could cause this..no the windows were not open or the...


Not familiar with the Volvo, but many cars (Toyota, Lexus, Acura, Honda, etc.) have drain holes at the corners of the sun roof assembly. These holes allow water that gets past the sunroof gasket to drain through tubes that carry the water to the bottom of the car, where it exits the car.

These drain holes are prone to clogging. If the Volvo setup is like those cars mentioned, you can see the front drain holes by opening the sunroof and looking closely at the two front corners of the assembly that holds the sunroof. I have used plastic weedeater line to open up these lines. Compressed air can also be used.

Oct 14, 2009 | 1998 Volvo V70

1 Answer

Sunroof stuck in the open position. can;t close.


The problem is probably the 'flap' of metal that's popped up, just above the where the handle is.
The runners/rails have undoubtedly corroded, and now there isn't anything to pull it down.
Luckily, as a 'Get the roof shut cos it's p*^%g
down' solution,,.
You can just hold your finger on the flap, to hold it down, in between the sunroof, and hole as you shut it.
Just remember to remove your finger Before you finish closing the sunroof.
Happy motoring.

Jun 29, 2009 | 1988 Volvo 760

2 Answers

Need to fix the sunroof of a 2000 Volvo S80 . It


hold the switch down for around 20 seconds and it reset the sun roof /in close position

May 09, 2009 | 2000 Volvo S80

1 Answer

2002 Oldsmobile Alero Sunroof Stuck in the Vent position


The sunroof continues to open and close normally from front to back, but the vent stays open.

Apr 01, 2009 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2001 Volvo V70 Logo

825 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...