GPS and radio controls not working. Can hear motor spinning under dash.
SOURCE: 2000 Toyota Sienna passenger side door won't close
I too had this problem. The first several times i tried the reset process (page 23 of the owners manual) it made no difference.
It appeared to me that the computer did not properly know where the door was actually located. like you , my door would not close. in fact, base on the sound, it sounded like it was trying to open when it was already open. I knew i had to figure out a way to "trick" the computer into relearning where the door was.. as crazy as it sounds
With the battery on, I opened the door with the button, before it could open fully, i closed it again with the button. I did this several times. I also experiment with shutting off the power (using the on/off button) in mid operation. Eventually it would close but pop back open again. At this point, I then did the reset procedure and it worked!
I am not a mechanic but a pretty decent electronic/computer guy. All i know is it worked!
:)
Adam
SOURCE: My 1998 Toyota sienna will not start
The battery may be dying and does nothave the juice to turn the crank.
SOURCE: Where do I find the fuse that controls the radio
On the engine compartment, check the cavity 13 20Amp (car audio systems). Also can review the 2002 Toyota Sienna - Owners Manual (page 321).
Hope helped with this (remember rated this help) Good luck.
SOURCE: How do I fix a boken power outlet in my 2005 Toyota Sienna?
take a 12v test light + wrap the probe with elec tape leave about 1/4" of
the tip exposed now with key on touch the to the ctr. +contact in the
outlet touch the ground to the metel side of the outlet if it lights the
outlet is working check ground on plug move side to side in the
outlet and see if your device works if the light don't come on try another
ground locationif still no light check power wire behind outlet
now this info is based on the theory the outlets share the same fuse
you can also check there. hope this helps good luck.
SOURCE: Toyota error code P2118
I don't have a Sienna but I do have a 2008 Toyota Camry SE. After it being in the garage for many months, 8 months I think, I had to give the battery a jump to finally start it up. Well The jumper cables I used weren't that great. They flickered and seemed to smoke a little. So i removed them and put a better set on to get a charge. I didn't think anything of it. After that charge came through and i was able to accelerate at all... The throttle was to the floor and the car would not even go up .5 RPMs... After several days and talking to the dealer, I was about to call a Tow to have it taken to the dealer. Luckily my friend came by with one of those diagnostic readers and it spit out the P2118 error code. Immediately we looked it up and found this site. Thanks to Fixya.com I was able to determine that it was a freakin measly fuse that blew due to bad jumper cables... Thank god for the Fuse and thank you to Fixya.com that I was able to determine this so quickly!!!
66 views
Usually answered in minutes!
×