Question about 1992 Dodge Viper

1 Answer

Not electrical response.

Absoletly no electrical with or without key i adjust anything in the driver seat that might move to see if that would work but nothing. I drove it just before it died. i went back to drive it again but the above secnerio happened. plz i am hopeing you guys can save me a lot of my by not having to take it to a shop.

Posted by on

  • cyberdude112 May 12, 2009

    ha yeah i can do some dumb stuff but yeah it is like its dead but its not its full i checked three times

  • cyberdude112 May 12, 2009

    mmm ok ill try that tomorrow thanks so much ill let you know how it turns out

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 28 Answers

Did you try jump starting it? if nothing electrical is working it sounds like a dead battery

Posted on May 12, 2009

  • tpeterson20 May 12, 2009

    there are main fuses that are larger than the rest that are in the fuse box in the engine compartment that could have blown. you can check those. also check for bad connections at the battery terminals... look for corrosion or rusted wiring. could also be a bad ground. follow your negative cable down to the frame or wherever it mounts to the car and make sure the connection is clean and tight.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Subaru Baja - driver seat will not move forward and it will not pitch forward either. It is not electric. Any ideas how to fix? Thank you.


need to look under seat either debris stuck in track at latch release or cable that is used to release it broke or is disconnected

Oct 12, 2016 | 2005 Subaru Baja

1 Answer

Controls on driver's side Power seats stopped working. Can not adjust seat at all.


The motors responsible for moving the seats are not being properly powered. The issue could be due to blown fuse, bad relay, bad connections, bad switches, ad infinitum. In short, any part in between the power source (battery) and the motor is suspect.

Get a hold of the wiring schematic for your car, study it, and get to work.

Feb 26, 2016 | 2005 Mercury Grand Marquis

1 Answer

Driver side electric seat is stuck in the far forward position and won't move. How do I move it manually or fix the motor.


Auto Repair: How to Replace a Power Seat Motor - YouTube

? 1:44
https://www.youtube.com/watch?v=EDh-0rs5Fjo
Oct 26, 2010 - Uploaded by automdvideos
Auto Repair: How to Replace a Power Seat Motor ... 2007 - 2008 Ford Expedition/Lincoln Navigator Driver Bottom Install Video ...2003-2006 Chevy/GMC Seat Cover Install 1 of 3 - eBay Ready ...2000 Ford Explorer Front Seat Track Stuck Motor Repair - Duration: 4:39. by cubmancan 4,959 views. 4:39.
Drivers seat is dead! No power seat or heat. - TheDieselGarage.comwww.thedieselgarage.com/.../96465-drivers-seat-dead-no-power-seat-hea...Mar 22, 2010 - 2003-2005 Chevrolet Avalanche, Silverado, Suburban, Tahoe 2003-2005.... Power seat on driver side didn't work.....passenger did! Neither ...DANG electric seat ' Chevy Truck Forum ' GM Truck Clubwww.gmtruckclub.com/forum/threads/dang-electric-seat.2990/Apr 27, 2006 - 10 posts - ‎7 authors'03 Tahoe My driver seat just stopped, of corse not where I need it, the ... I have a 2003Tahoe and both heated seats are not working. ... with my seat heater on the drivers seat in my 03 Avalanche, it turns ... The driver's side on my Silverado gets way warmer than the passenger side. ... Frozen New Member.Power Seat Problems?? - Tahoe Forum - Che

Dec 29, 2015 | 2003 Chevrolet Avalanche

1 Answer

Acadia driver seat electric adjust not working and driver and passenger heater not working


reconnect and the connect back the cabel joint under ther the driver seat

Nov 24, 2013 | GMC Cars & Trucks

1 Answer

Hello, need your advice to solve the problem, saab ss 2003 driver electric seat (without memory) doesnt move to any directions. I suspect that problem with relay (didnt find any fuse responsible for that)...


Unless this is a convertible then there is no relay for the seat in the trunk. The relay is supposed to be under the driver's seat. Look for the Red wire going to the seat switch, that should be 12 volts with the key on. The brown wire should be ground. The best way to test power & ground is to use a headlight (sealed beam) & try to power that up with the power & ground going to the seat switch. What that does is make sure that there are no bad connections & you truly have good power & ground. Maxi fuse #4 powers up the seat relay.

Mar 10, 2011 | 2003 Saab 9-3

1 Answer

My electric drivers seat don't work. Is there anyway to adjust the seat manually until I can replace the memory control module? Thanks,


unfortunately there is no way to adjust the seat without the controls working. sorry. Hope this helps. Good luck.

Jan 09, 2011 | 2003 GMC Yukon

1 Answer

Pt cruiser seat adjuster problems - my drivers seat power seat adjuster doesn't work (as of yesterday ) and it is stuck in the fully forward position - it there anything i can do? it would only move up...


You might have a problem with the wiring under the seat. The best thing to do is to reach under the seat and move some of the wires away from the track that the seat moves along. Most likely there is a short to ground because the wires are rubbing against the seat track as it is moved back and forth. You need to grab a flashlight and look under the seat for wires touching the seat tracks. When you find them, you can most likely use some electrical tape to wrap the exposed wires and keep those wires from touching each other and that area from touching the seat track. Make sure you route the wires away from the seat track tight enough to the seat's underside, but loose enough to allow the wires to move with the seat as it travels the full length of its track. The fuse for the seat has probably blown so you would need to replace the power seat fuse AFTER you wrap and reroute the wires to prevent blowing the new fuse.

Hope this helps!

Sep 06, 2010 | Chrysler PT Cruiser Cars & Trucks

3 Answers

Olds Aurora seat wont adjust


Check on the side of the seat for a manual lever. For some reason the car companies still include a manual adjustment in addition to the electric one. If any direction works with the motor then the fuse is good.

Jun 18, 2009 | 1997 Oldsmobile Aurora

1 Answer

Power front seats


Before you start beating up thing's , test the electrical circuits. Do you know anything about automotive electrical systems ? How to use a volt meter an a wiring diagram to test for B+ power to the switch an testing the ground .
Does your envoy have memory seats ? Your vehicle has four or more electric motors to control back an foward , up an down etc.. the odds of more then one motor being bad at one time are highly unlikely .
Look under the seat any trash under there keeping it from moving ?
If you have memory seats there is a control module involved in making the seats work . If it has memory seats it could have DTC'S - diagnostic trouble codes .
DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820
The seat adjuster switches are inputs to the driver and passenger seat modules. The seat modules supply the adjuster switch assemblies with a battery positive switch supply circuit and monitor the switch signal circuits. In an inactive state the switch signal circuits are floating and when a switch is pressed the signal circuit is closed to the switch power circuit within the adjuster switch assembly. When battery voltage is present on the switch signal circuit the seat module determines the switch status to be active.
DIY Blazer GMC Jimmy Power Seat Control Diagnostics and Repair Electric...

Jun 26, 2017 | 2002 GMC Envoy

1 Answer

Drivers side seat will not go up or down as designed.


You could remove the seat and check to see if there is anything jammed in the seat rails causing the seat not to adjust up or down. Remove the 4 Torx-40 bolts from the rails tilt the seat back and disconnect the connectors that are lined up under the bottom of the seat. MAKE SURE THE KEY IS OFF AND STAYS OFF. Check the rails, check the operation of the height adjust. If it still does not work then it most likely needs seat rails.

Mar 01, 2009 | 2005 Mini Cooper

Not finding what you are looking for?
1992 Dodge Viper Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...