Question about 2006 Jeep Liberty

3 Answers

The cruise control dont work in my 2003 jeep liberty

Cruise will not come on or display a light on the dash that says its on. Is there a fuse for the cruise? A relay? Any know problems with the cruise on this model, and also the air bag light stays on. Thanks

Posted by on

  • uncfan1958 May 10, 2009

    what is the clockspring and how do you replace it?

×

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Jeep Master
  • 412 Answers

Sounds like the clockspring is faulty under the steering wheel..

Posted on May 10, 2009

  • Robert Debison May 10, 2009

    a clockspring is a wire coil under steering wheel that links switches on wheel to steering column..it is in a plastic housing mounted to steering column..your speed control switches and air bag connectors go thru this to send signals to vehicle controllers for these items to work..you have to remove airbag from steering wheel,remove steering wheel and covers around steering column..really should only be replaced by a trained technician..it is dealer part..do not recommend a junkyard part

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Same problem here - turned out to be the Vacuum line from the left rear of the engine on the firewall up to the right side of the throttle body ? air intake.
Plugged it back on the hose connector - problem solved.. Works perfect again..

Posted on Jun 03, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 2005 Wrangler - Same problem here - turned out to be the Vacuum line. Plugged it back on the hose connector - problem solved.. Works perfect again..

Posted on Sep 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse location for cruise control


Since there is no throttle cable, there is no "cruise control" fuse. The fuses used are #7, 9,and 13 in the under hood fuse/relay box and #18 in the under dash fuse/relay box. The most common failure is a bad brake pedal switch. Does the cruise control main switch "on" light work when the switch is pressed? The gauge control module (instrument panel) and the PCM control the cruise control.

Apr 05, 2015 | 2006 Honda Ridgeline

1 Answer

I don't know where relay horn and cruise control


there should also be a srs light on the dash illuminated?! the problem is the clock spring behind the steering wheel. happy holidays

Dec 28, 2009 | 1999 Honda Civic

2 Answers

2003 expedition cruise control inoperative no cruise light on dash when buttom is pushed. All fuses in fuse box checked OK. No data stream information on cruise buttons.


Check the speed sensor at the tranny or near left front tire. Use a manual or find the location on the net. This sensor usually causes problems with the cruise control.

Nov 20, 2009 | 2003 Ford Expedition

1 Answer

Cruise control quit working, so where should I check. I would like to know about the wires and fuses and where to trace them down.


The 1994-95 Chrysler Minivans have four electrical panels/fuse boxes.:
  1. Fuse Block Panel (In Dash)
  2. Relay Block (In Dash)
  3. Micro Relay Block (In Dash)
  4. Power Distribution Center (Underhood)
Fuse block is located on left side of instrument panel, behind access door. Speed (cruise) control fuse is No. 14.
Note: If you have an airbag light on your dash litup, it might be something called a clockspring, which you'll have to take to the dealership/garage to get fixed. (Dealership is probably your best bet)
Hope this helps! :)

Oct 20, 2009 | 1994 Plymouth Voyager

1 Answer

Cruise control just quit working


Check fuses/relays and make sure they are all good; if so check the electrical wiring/connectors in the dash. Jeeps are notorious for loose wires in the dash.

Sep 01, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Cruise control 1998 plymouth grand voyager not working


Check fuses under dash on drivers side, & fuse & relay box under hood on drivers side. I.D. for fuses & relays under hood on underside of cover.

Apr 09, 2009 | 1998 Plymouth Grand Voyager

1 Answer

Cruise control does not function


cruise on a ford escort?? not fitted to europeon model thats for sure.All fuses are in the fuse box above left knee ,unhook the fuse box and let it drop to get at relays.

Feb 18, 2009 | 1997 Ford Escort

1 Answer

Cruise doesn't work


Bad relay. They are to the right of the fuses (fuses inside the car). You can see the relays if you open the cover to the fuses (they are big blue cubes), but will need to remove a few screws to remove the panel to get to them. I can't remember which one it is, it might make a clicking noise when you try and turn on the cruise. Or you can swap "matching relays - compare diagram on top" and see what else stop working. I had to replace several, my dash when out, my cruise, and I think one is the fan that blows your ac and heat.

May 29, 2008 | 1994 Nissan Maxima

2 Answers

Cruise control quit working. Is there a fuse somewhere that I can check. None of the fuse box locations have a cruise control label


Bad relay. They are to the right of the fuses (fuses inside the car). You can see the relays if you open the cover to the fuses (they are big blue cubes), but will need to remove a few screws to remove the panel to get to them. I can't remember which one it is, it might make a clicking noise when you try and turn on the cruise. Or you can swap "matching relays - compare diagram on top" and see what else stop working. I had to replace several, my dash when out, my cruise, and I think one is the fan that blows your ac and heat.

May 27, 2008 | 1994 Nissan Maxima

Not finding what you are looking for?
2006 Jeep Liberty Logo

1,768 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...