Question about 2005 Jeep Wrangler

1 Answer

Left flasher dead, right on works

My 05 Jeep Wrangler right signal flasher works, but left flasher doesn't. Light blubs OK. Left flasher clicks faster than right. When parking light turned on, left turn signal steady light.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 131 Answers

Double check your bulbs again, if still good
check your flasher

G

Posted on May 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to repair left turn signal and brake light, changed bulb, No voltage in fuse box, fuse is ok


No voltage. Replace the turn signal switch. All the exterior lights run threw it. Except the rear high brake light.

Apr 08, 2015 | 2013 Jeep Wrangler

1 Answer

Left bleaker and break light not working. Turn signal works bleaks faster than right side.


Has the vehicle been in an accident on the left rear side. First check the bulb to be sure it is not defective, trade it out with the side that works properly to test. If the bulb works well then My thought are you may have a shorted wire. The turn signal flasher works by heat build up within the flasher the heat is caused by the load of the bulbs, the load heats the metal spring causing it to open the circuit then as quickly as it cools down the circuit closes again lighting the bulbs.
There is also a possibility of a defect in the turn signal mechanism on the steering column. The turn signal switch on many models does three different things on many models that use the same bulb element / or bulb for brake and turn on rear of vehicle. It controls the circuit for brake light by sending power both left and right side rear when turn signal is in neutral position then when turn signal is in left turn the switch cancels brake light power to left side rear and supplies flasher power to left side while maintaining brake light supply to the right side rear, and so on opposite when the right turn is chosen on turn signal switch. The turn signal indicators on the dash normally run off the same circuit as front turn signal bulb only which is also controlled by turn signal switch. Front has turn signals but no brake light.
I think there is an additional load on the left side rear turn circuit and it could be either a wire that is shorted or the turn signal switch if the same bulb element is used for both functions.
Often times if trailer lighting is connected the flasher will also blink a little faster because of the extra load of additional bulbs.

Feb 15, 2015 | Cars & Trucks

1 Answer

Where do I find a fuse diagram for a 1998 Jeep Cherokee (4.0)


the next step is to check fo voltage going to the signal socket and check the ground, the flasher clicking faster means you got a light not working

May 05, 2010 | 1998 Jeep Cherokee 4WD

1 Answer

Left turn signal works / don't work, brake light


possibly flasher unit faulty
or turn signal switch

Feb 22, 2010 | 2000 Jeep Grand Cherokee

2 Answers

I have a problem with a 93 Jeep Cherokee Laredo 4W - The right blinker & brake light works like they should. However,the left brake & backup lights are out ( new bulbs have been installed &...


a very bad earth in that lamp holder,, clean all the earths and try another new buld in it, iv had this before and that was the problem sorted

Nov 02, 2009 | 2000 Jeep Wrangler

1 Answer

Jeep Liberty 2002 - I get a fast blink on the left turn signal (but a normal blink on the right). Where is the flasher located?


Normally when this happens you have a blown bulb on either the front or rear the fast blink is because with only one bulb working the flasher clicks it faster less of a load means faster blink.

Sep 28, 2009 | 2007 Jeep Liberty Sport

1 Answer

Left rear turn signal and brake light dont work


You have a broken wire to the turn/brake light portion of the light as they use the same wire. Or where the plug goes into the light assy could be bad. Torsion mount lights are horrible and you should think about replacing with a universal light that you can wire direct.

Feb 17, 2009 | 1997 Jeep Wrangler

1 Answer

Jeep Liberty Left Rear Turn Signal Not Working


sounds like the bulb you have is the wrong resistance the new noen bulbs will do this

Nov 16, 2008 | 2004 Jeep Wrangler

1 Answer

1998 wrangler turn signal/brake light short


your socket may not be grounded properly, I have seen this before, and the simplest way to fix is change the socket with a new one.Not another used one it may also be bad.

Jul 30, 2008 | 1988 Jeep Wrangler

Not finding what you are looking for?
2005 Jeep Wrangler Logo

Related Topics:

340 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...