I need the torque settings for a huyundai terracan 2.9 j3 motor

You just go to the link I attached I'm sure you will get the solution of your problem -

https://www.reliable-store.com/products/2005-hyundai-terracan-workshop-repair-service-manual-pdf-download

Main bearing stage 1: 25NM, stage 2: 50NM
Big-end bearing stage 1: 14NM, stage 2: 28NM
Cylinder head stage 1: 30NM, stage 2: 60NM

Morning please advise on Torque settings for big end bearings on a ascent 1.3 X's please.

the FSM covers all this, buy one, or log in to alldata.com
yes, all bolts on the engine are set at a spec. torque.
you didnt state , engine size option, so nobody can answer, exactly.
but all bolts all all parts, should be staged down, to the spec.torque.
some bolts 6mm need to be set to 80-100 inch/lbs. not FOOT.
and if you exceed that much, they strip or snap, making an easy job
1000x more hard.
usually sequence maps (off and on differ) are limited to head bolts and cam cap bolts. but not always, that is why reading the FSM on your car
and your engine options is best. and all those warning there.
include steps telling you to use RTV sealant at special places.

alldata.com log in , read the engine chapter, its all there , all the time.

You need to tap into the high beam RELAY power. The computer uses a signal to switch on the lights, it sees a signal and tells the relay to come on using a lower voltage or even as you suggested a ground, when the relay closes it sends voltage to the lights.

I am also trying to find out where the blower resistor is on a Hyundai terracan 2006. On here someone says its on the passenger firewall is it beneath the battery I cant find it

Ok i could be 1 of 3 things blower relay,blower switch or blower motor resistor.First thing to do is check the blower motor resistor by pulling on and wiggling the pigtail to the resistor with the ignition and fan switches on.Then if there is no bad connection i would replace the relay and if no change afterwards replace the fan switch.

Check this website, you find there fuse box diagram and description for Hyundai Terracan

Hyundai Terracan 2005 2007 fuse box diagram Auto Genius

dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm

From front to back is this:


7 3 1 5 9



8 4 2 6 10



First torque value is 58 ft lbs.....then final torgue is 72 ft lbs.