Question about Toyota Camry
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: starter replacement
my solution is for all cars and not specifically for a camry.
remove the positive wire of the battery.
remove all the wires attached to the starter.
take note on where you took them off.
remove all the bolts holding the starter.
remove the starter.
do the reverse on installation.
last thing to do is put back the positive wire of the battery.
tnx 4 using fixya,
Posted on Sep 09, 2008
Removal of the plenum is pretty straight forward. You will need to replace the plenum gasket after you remove it; the gasket is not reusable. Personally, if I was going to take the trouble to remove the plenum, I would replace the plugs and wires back there, also.
I know, I have a 93 Camry V6, and it is a real pain to do the plugs and wires with the plenum on. There are no secrets or great tips on the plenum removal, just take your time. Remember that there are different size bolts, and where they go. Please get back to me if you need any more info...Hope this helps, and thanks for choosing FixYa to resolve your issue.
The graciousness of a FixYa rating for my assistance would be greatly appreciated.
Posted on Dec 15, 2008
That code is for the evaporative emmisions system. Here is a link to an open forum you can go to, this will help you understand what it is, and why. The vehicle on the site is a van, but the code, and parts involved are one in the same, so don't worry about the difference in vehicle. The van is a toyota, and this is the information on the p0446 code. Hope this helps you.
Posted on Mar 08, 2009
Not a quick job. You need to remove the instrument panel. once removed the bulbs simple twice a quater turn and you can replace them. removing the instrument panel varies on different cars, often you can do it without removing the steering wheel. You would normally take off the plastic under the steering wheel. lower the steering wheel as far as it will go. there should then be screws holding in the plastic around the instrument panel.
Posted on Jun 16, 2009
SOURCE: 1992 Toyota Camry won't crank
Check the ground cable going from the battery to
alternator, then to chassis. Make sure there is no
rust at the chassis ground wire terminal, and that it
is very tight. The fusible link will be off the alternator
red power cable,usually, but not 100% on that car.
Posted on Mar 30, 2010
Tips for a great answer:
Mar 07, 2011 | 1997 Toyota Camry
Jan 03, 2011 | 1997 Toyota Camry
Sep 05, 2010 | 1997 Toyota Camry
Jan 22, 2018 | 1998 Toyota Camry
Mar 03, 2010 | 1997 Toyota Camry
Sep 02, 2009 | 1997 Toyota Camry
Jul 20, 2009 | 1997 Toyota Camry
Jul 06, 2009 | 1997 Toyota Camry
1,908 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: