Question about 1998 GMC Jimmy

1 Answer

I have the light "Check gages" light on and off on my Jimmy 1999 model. What are the all possible causes of this issue?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 14,036 Answers

Give me more detail .tell me a little more .what light is you referring to.

Posted on May 09, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My overhead comp/temp lite stays dim all the time on my 1999 GMC Jimmy


Internal Faults in Distributor Can Cause Engine Problems ...

repairpal.com > Problems > GMC > Jimmy
Driveability Problems Due to Internal Distributor Fault on GMC Jimmy. The distributor may ... This can cause a rough running engine or stalling condition, the Check EngineLight may or may not illuminate. ... 1999 GMC Jimmy150,225Visitor.

Aug 30, 2015 | GMC Cars & Trucks

1 Answer

1999 GMC JImmy Security light


ill assume that white thing is the part that reads the chip in your key. could be the problem but i wouldnt just throw parts at it

Oct 07, 2017 | 1999 GMC Jimmy

1 Answer

Where is the reset swich located


Hi, there are no reset switches, if your jimmy does not start, you need to check for fuel pressure,(55 psi),spark, and make sure there is no security light on. If the security light is on, there may be a computer issue causing a no start.Good luck...

Sep 23, 2010 | 1999 GMC Jimmy

1 Answer

1999 model gmc jimmy.when the fuel gage reach one haft the engine stop when i step on the brake


Might Be, a Clogged Fuel Filter, cause if you have alot of dirt in your tank, or strainer in the tank get clogged cause when you step on the brake all the dirt hit the pump !

Aug 10, 2010 | GMC Jimmy Cars & Trucks

1 Answer

Had some noise coming from under my 1999 gmc jimmy 4wd I was told that it was coming from the differential case ,,I drove it home and the noise went away and now some of my gages dont work ,,,any ideas


if the noise is increasing as per speed of car then it is a differantial or wheel bearing and if it is not then some thing else. what gages is that?

Jan 16, 2010 | 1999 GMC Jimmy

1 Answer

Check Gages light comes on 99 GMC Surban


one of the gauges must a fluxuated enough to have the computer turn the light on,I've seen mostly gas gauges fluxuate,but train your eye where the voltage is in normal mode because it will still look like the needle is up there but it may only be 11 volts instead of 13-14 volts running.

Dec 07, 2009 | 1999 GMC Jimmy

1 Answer

What is the check gauges light


CHECK GAGES light (1) indicates a potential engine failure(low oil pressure, low coolant, coolant overheating) has occurred.
· Check gages and shut down engine. Gages should read as follows: Oil pressure 5 to 10 psi (34 to 69 kPa) at idle; Water Temp gage below 230 degrees (110 C).
· Check engine oil level (Para 2-11) if OIL PRESS gage indicates low reading. Check coolant level (Para 2-11) if Water Temp gage indicates high reading. Notify Unit Maintenance if levels are low.

If CHECK ENGINE light (2) is on, check engine oil pressure gage (3) and water temperature gage (4). If both indicate normal, proceed with mission and then notify Unit Maintenance. If either one does not indicate normal, stop engine immediately and notify Unit Maintenance


Oct 16, 2009 | 1999 GMC Jimmy

1 Answer

99 jimmy 4wd sl trans issue have fwd & rev but....


It sounds like your describing your torque converter and that its staying unlocked. you might want to check your brake light switch/s if they are malfunctioning it could cause your problem. Also possible that your fuel filter and/or CAT might be clogged.

Apr 25, 2009 | 1999 GMC Jimmy

1 Answer

Dash Gages


bad altenater or short in wiring

Oct 25, 2008 | 1997 GMC Jimmy

Not finding what you are looking for?
1998 GMC Jimmy Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...