2006 chrysler pacifica doors locked with key in ignition

2006 Buick Rendezvous Remote Programming For Buick Rendezvous / Intrigue / AztekObtain all remote transmitters for this vehicle.
1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release in step 6.
3. Insert key into the ignition cylinder but do not turn it.
4. Remove key from ignition and then insert key into ignition without turning ignition cylinder and remove key.
5. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.
6. Release door lock switch on drivers door panel. A Chime will sound 3 times indicating that you are in programming mode.
7. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
8. Repeat step 7 if you are programming additional remotes.
9. Remove key from ignition to exit programming mode

BCM -- body control module problem or a switch input to the BCM Or the TIPM totally integraded power module has a problem . Your best bet would be to take your vehicle to a qualified repair shop that has the tools and knowledge .

Try unlocking the passager door

major electrical issue. its a Chrysler. Did you recently have the vehicle worked on?

Do you have USAA insurance? I believe they have roadside assistance included in your policy which may include unlocking the door. Try calling your insurance carrier either way and find out if a locksmith is covered. On these newer vehicles I'm not sure if the old school slim jim works to unlock them.

could be batterys or need reseting should be in owner manuel

Have you checked the fuses for those circuits ?

This can happen If you have used the IGN. key to unlock the drivers door after you locked them from the fob. This can also be caused by a stuck button on the drovers door. Check the drivers door all buttons to see if any are stuck. If you do not have any stuck buttons. Try this, from inside the car, with out the car running, use the button on the drivers door to "lock all doors". Then use the fob to unlock them, then get out and press the lock button on the fob twice real quick. This should cause the drivers door to lock as the others. Hope this helps Fix Ya Up.

Change the battery in your remote.Other wise you may have a faulty alarm unit. And you will need to take it to the dealership.

you have to go to your dealer and have the key made and programmed for your computer. its not cheap last i checked $100 bucks or so good luck.