Question about 1999 Chevrolet Blazer

1 Answer

1996 ford ranger it starts but has no power when you give it gas

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

I would start by replacing the fuel fiter, cheap and easy. If not that does it have a coil pack for each sparkplug? if so it could one of them or even a couple, take a look and see if it has them. But i would start with the fuel filter first

Posted on May 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Ford ranger xlt stutters and jerks when i press the gas


check your plug wires. sounds like u have 1 arching

Sep 18, 2013 | 1996 Ford Ranger SuperCab

1 Answer

1996 ford ranger will not stay started I put gas in the carb but it only runs for a min. Ran for two day good then just stoped


sounds like fuel pump in tank is not working. Can you hear it hum when you turn key to ON?

It should hum for 5 seconds and build up 40 psi of fuel pressure.

Oct 21, 2011 | 1996 Ford Ranger SuperCab

2 Answers

1996 ford ranger xlt 4.0 starts ok if you keep gas on it runs good let off the gas spit and sputters then dies


check the position of the throttlebody the throttlebody must not close properly there must be a gap when fully closed if theres a throttleposition sensor replace it

Aug 03, 2011 | 1996 Ford Ranger SuperCab

2 Answers

Emission test showed error code p1443.check engine light stays on.1996 ford ranger.I looked the problem on ford emission control error and says it could be canister,purge flow sensor or purge valve.I would...


You might want to try "google images" just type in your vehicle and what your looking for. Here's an example (link) of what to look for.

http://www.fordmuscle.com/forums/attachments/all-ford-techboard/4132d1212515121-code-p1443-help-96tbird_evap.jpg

Oct 25, 2009 | 1996 Ford Ranger SuperCab

1 Answer

I have a 1996 Ford Ranger extended cab with automatic transmission. In drive the transmission slips. It just started to do this after a replaced gas tank. I checked the fluid and it is at correct level....


Run and obd2 scan at autozone or advance. this is free. This will let you know if any sensors are bad and it will give you a course of action. It could be your input or output speed sensor or your ECM or TCM. Exhaust these options before pinpointin the transmission as the problem Its also possible when they replaced the gas tank they dislodged a ground connection. Good Luck

Dec 08, 2008 | 1996 Ford Ranger SuperCab

1 Answer

Fuel guage goes to empty when i start my truck. when truck is off it will show 1/4 tank. 1996 ford ranger 4x2 11340 miles. very low miles for this truck didn't know if it may of had a recall when it was...


if it has a recall then call ford up and give them the vin. They have to tell you if there is a recall on it by law. It sounds like you have a bad wire, some where. you need to get under the truck and start testing all the wires from the gas tank sending unit.

good luck..

tepfy

Oct 31, 2008 | 1996 Ford Ranger SuperCab

1 Answer

1996 ford ranger -3.0 ltr


Had a similar problem and it just ended up being the sensor for the EVAP controls.  Stupid I know but it fixed the rough idle. Error code was P1443. Worth a try.

May 30, 2008 | 1996 Ford Ranger SuperCab

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...