Question about 1998 Plymouth Voyager

1 Answer

1998 Plymouth Voyager turns over but won't start

ECM is good, distributor module is good, fuel pump is working & ignition has power. All fuses & breakers are good. Am I missing something? What else do I need to check.

Posted by on

  • Dudeman321 May 11, 2010

    Have you removed a spark plug boot and cranked it over, to confirm there is spark? Also if its not too hard remove the fuel line to make sure there is fuel pressure there. Don't take it off all the way just enough to see that its squirting out. Do the fuel thing while the ignition is off, you probably don't need a fire. Post your results back

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 334 Answers

I would check the timeing belt. to see if it has a bad spot

Posted on May 09, 2009

  • michael billington May 09, 2009

    i would check the timeing belt. to see if it has a bad spot

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 plymouth grand voyager wont start changed the fuel pump and filter replaced the ecm, ignition coil and checked all fuses it started up after changing fuel pump it ran for like twenty min then died


Hello
The engine and transmission in this cars drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL THE DIAGNOSIS & TESTING IS COMPLETED.

Jul 08, 2012 | 1997 Plymouth Grand Voyager

1 Answer

My 98 gmc 1500 V8 5.0l won't start. Has good spark


Spray starting fluid into the air intake of the engine, if it starts and you have fuel pressure you have no injection or injector pulse as we call it. Check ECM fuse one and two for continuity if it starts with fluid..

May 25, 2012 | 1998 GMC Sierra

1 Answer

1992 Plymouth Grand Voyager won't start, fuel pump runs for about 1/2 second when you turn on the key


The power control module sends signal to the fuel pump relay, it gets it's signal from the pick up coil in the distributor and the crankshaft position sensor. I'm having the same issues with my 94 Jeep Wrangler

Apr 23, 2012 | 1992 Plymouth Grand Voyager

1 Answer

Changed water pump now 1998more plymouth grand voyager wont start


Check all your wires you removed. Obviously something is not connected. Check your ground wires first. When you have determined you have a good ground then check for power to the starter. If it cranks but won't start then you have disconnected something to the fuel or ignition system. If it ran before you changed the water pump then you have missed a connection somewhere.

Mar 24, 2012 | 1998 Plymouth Grand Voyager

1 Answer

1998 Plymouth grand voyager ignition won't turn


I have had this happen on my 98 Voyager. Just have a new key cut. This new key will sometimes cure the problem. The older keys get worn out and won't unlock the ignition. Try this before a much more expensive and time consuming change of the ignition.

Nov 01, 2011 | 1998 Plymouth Voyager

2 Answers

My 1998 jeep cheorkee engine turns but won't crank, could it be the computer or what?


it's highly unlikely, there are only two things that can make this happen, not getting fuel (fuel pump failure, fuel pump regulator) or not getting ignition (bad coils, ignition module failure, bad distributor, distributor cap, rotor)

Jun 24, 2011 | 1998 Jeep Cherokee

1 Answer

My 93 plymouth voyager won't start unless I spray starting fluid down air cleaner, then it only runs a few seconds.


Listen for fuel pump when turning ignition to on position. If no pump sound, locate fuel pump fuse and relay in box under hood. First check fuse, then listen to relay while ignition is turned to on. Relay should click. If no click, replace relay. If click, circuits are good and pump is likely bad. Please reply if you have questions.

Sep 09, 2010 | 1993 Plymouth Grand Voyager

2 Answers

My truck will not start just cranks but will not fire


Air - not likely the problem ! mechanical cable controlled throttle body

Fuel- make sure there is gas in tank! fuel pressure test at the throttle body or rails, if no fuel check power to fuel pump: ignition power to breaker or fuse, relay , power to pump at 3 pin connector near tank/frame rail on drivers side, - if pump is runniig but insufficient pressure, check for mechanical restriction: plugged filter broken or pinched line, plugged pickup tube in tank. if good pressure to rail or body, check ecm : diagnostic codes, fused power, ecm tells injectors when to open, dependent upon several sensor parameter inputs.

Spark- ignition - coil-distributor-ignition module (or coil packs)- wires-plugs-ignition module (signals coil to discharge, mounted beneath distr cap) work backwards from plugs.

Jan 25, 2010 | 2000 Chevrolet Silverado

1 Answer

On my 1994 plymouth voyager the 3 wire harness to fuel pump (blue wire) doesn't have 12 volts; should it? fuel pump quit then worked once when hot-wired with 12 volts. fuse and relay is good.


The wire should not be hot until the relay is triggered. The relay does not get triggered until the ignition key is turned on. It will run for 3-5 seconds or until the system pressure it at max.

Apr 26, 2009 | 1999 Plymouth Grand Voyager

2 Answers

99 voyager no crank, wipers, radio and power windows. bcm?


Check power distribution panel near battery for blown fuses.

Feb 08, 2009 | 1999 Plymouth Grand Voyager

Not finding what you are looking for?
1998 Plymouth Voyager Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...