Question about 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

P1316 code check engine light on

Smokes white and misses when it's cold

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 93 Answers

Its a bad injector wire

Posted on Dec 03, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
redbeard00
  • 957 Answers

SOURCE: My 1994 Ford Thunderbird now smokes when I start it - no noises in the engine, but smokes like crazy. Check engine light is one now?

state what color the smoke is. White smoke is antifreeze. Gray smoke is fuel, and black smoke is oil. Also have the computer scanned so you know why the light is on.

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: lack of power misses at road speed smokes on

cold power issues and intermittent smoke sound more like egr issues as these can be quite a problem on 6.0 liter. remove valve and clean

Posted on Jan 07, 2010

  • 145 Answers

SOURCE: have and engine code of P1316 and engine is

1316 is an injector code. If this is a Powerstroke you probably have an injector misfiring.

Posted on Jan 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Parked my 05 Jag in garage for 4 months ran perfect . Just started it up got all kinds of codes Lots of miss fires PO303 PO304 P1316 Injector circuit P1316


There is every possibility that the the CPU program was corrupted by he long time the battery was not being charged . use a scanner to reset the program and then see if the fault codes persist.

Dec 07, 2014 | Cars & Trucks

1 Answer

I have a 2005 cadillac STS. 87,000 miles. It smokes out of the tail pipe when car is sitting still. The smoke is white. I just had an oil change yesterday. My car says that i should check the coolant....My...


Start by getting the codes from the computer. Once you have that, then start tackling the problem. White smoke is usually burning coolant. This is typical of a bad gasket (lower intake or head gasket) If it's cold you will see a little bit of smoke. Does it idle poorly or have a hard time accelerating?

Dec 10, 2013 | 2005 Cadillac STS

1 Answer

Smokes when cold and stops once it warms up


How many miles on engine?. What color smoke? If white clouds of smoke that goes away when it warms up that indicates a possible housing seal. Another symptom would be having to add coolant. view this video -> https://www.youtube.com/watch?v=4H-B1nckyFE

Nov 20, 2013 | 1991 Mazda RX-7

1 Answer

PO380 and p1316 what do thies coads mean.


P0380 - Glow Plug/Heater Circuit "A" Malfunction
Bad glow plug. The glow plug system is used to assist in providing the heat required to begin combustion during cold engine temperatures. The glow plugs are heated before and during cranking, as well as initial engine operation. The engine control module (ECM) controls the glow plug ON times by monitoring coolant temperature and glow plug voltage. The California Glow Plug system has eight individual glow plug supply circuits between the controller and the glow plugs. If the feedback voltage from the controller to the ECM is not within range, DTC P0380 will set.

- The glow plugs are commanded OFF and the glow plug feedback is more than 2 volts. or
- The glow plugs are commanded on and the glow plug feedback is not between 5 volts and 6.2 volts.

Keep in mind that the "wait to start" light only comes on while the voltage is dropping in that circuit. This should only take 3-5 sec's. If it takes longer, refer to your "Likely problem" you listed above. That would be the Heater Module. If your glo plugs stay on, your batteries would be dead in no time. If any of your plugs go bad, they would each be listed on the reader per cyl 1-8. If you need to change the Module,


P1316 - Injector Circuit / IDM Codes Detected.
This code indicates that codes are stored in the IDM

Possible causes are as follows:
- Injector(s) or circuit(s)
- Open or shorted IDM enable circuit
- Open/short in EF circuit
- Open/short in FDCS circuit
- IDM relay
- IDM powering circuits
- Failed IDM
- Failed PCM

Check your Injector Driver Module wires, circuits 821 (Brown/Orange) and 818 (Grey/White) between the PCM and IDM. On the IDM side, the connector pin numbers are 17 for circuit 821, and pin 4 for circuit 818. You should check for high resistance in that circuit, short to ground, or open circuits. If wiring checks out good, you may need to replace your IDM. It's not uncommon for water intrusion into the module, due to its mounting location. Also check the engine wiring harness where it routes up over the driver side shock and/or driver side valve cover. That code is either a key-on/engine-off or a continuous memory code.


Hope this helps (remember to rate this answer).

Feb 04, 2011 | 1999 Ford F350 Regular Cab

2 Answers

2002 ford f450 7.3 diesel runs ruff and has trouble code p1316 any ideas


P1316 Injector Circuit/IDM Codes Detected .....FJ9 DIAGNOSTIC TROUBLE CODE (DTC) P1316 INDICATES THAT CODES ARE STORED IN THE IDM
Possible causes:
Injector(s) or circuit(s)
Open or shorted IDM enable circuit
Open/short in EF circuit
Open/short in FDCS circuit
IDM relay
IDM powering circuits
IDM
PCM
Check for other codes.
Key on, engine off.
Perform KOEO On-Demand Self Test.

This tells me that the IDM DOES store codes.
Trying to make sense of this. Which test will then give me the codes stored in the IDM? I am pretty sure we did the self test and did not get additional codes

Jan 09, 2010 | 2002 Ford Super Duty F 450

2 Answers

Lack of power misses at road speed smokes on occation dealer said injectors were missing randomly no engine light no power when cold hardly pull it's self when cold 04 powerstroke 6.0


sounds like a good fuel system clean is needed! also make sure there is a clean air filter, as they kill alot of power and will end up causing more fuel to **** through and partially burn giving smoke!

Dec 04, 2009 | 2001 Ford Super Duty F 450

2 Answers

My 1994 Ford Thunderbird now smokes when I start it - no noises in the engine, but smokes like crazy. Check engine light is one now?


state what color the smoke is. White smoke is antifreeze. Gray smoke is fuel, and black smoke is oil. Also have the computer scanned so you know why the light is on.

Apr 25, 2009 | 1994 Ford Thunderbird

Not finding what you are looking for?
2003 Ford F350 Super Duty DRW SuperCab Logo

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...