Question about Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
BAS is the Brake Assist System and if there is a malfunction it would only come into play in an Emergency stop while applying full pressure. BAS applies full braking force because people tend to lighten up their pressure on the pedal in these situations. I would suggest that the best thing to do is go to a Workshop or Service Center and have it checked out. Please remember to put a good rating on my profile.
Posted on Jun 26, 2008
the transmission on your MB is sealed with no way to check the trans fluid level,(no dipstick provided for) that is why the report says "sealed". MB did this to stop customers from overfilling there transmissions, which can cause severe damage if not done properly at the correct fluid temp, this requires special test scan tools.
Posted on Mar 30, 2009
Yes cars with timing belts have a schedualed time in service manual for replacement. this is very important if it breaks then you might be replacing engine. when doing timing belt you also have other items like timing belt tensioner and timing belt pulleys as well most of the time the water pump is driven by the timing belt and should be replaced at the same time. also all seals as well cam seals crank seals ect. timing belt is one of the most important items on cars today . great question most people wait untill its to late when it breaks. and what ever shop does it make sure they have a mechanic that does timing belts regulary and that they ask you about all the parts I mentioned to you as well that they clean all factory parts before they go back on.
Posted on May 31, 2009
brand doesn't matter but alot of these vehicles run a synthetic oil in them straight from the factory, i'm not one hundred percent positive on your vehicle about the grade but your owners manual will tell you near the back of the book exactly what to put in it.
Posted on Aug 28, 2009
hi this is showing fuel trim bank 1 malfunction, this could be caused by the following things, intake leak, AIR system, fuel pressure/pump, injector/s EVAP canister purge valve, or HO2S ( air fuel mix incorrect) if it starts and runs fine, i do not think it will be fuel pump, or the injectors as this would make it run rough or even not start at all, if it was an intake leak, you would be suffering from high rev's when you start the car and would take a long time for the rev's to come down, so really, that just leaves the HO2S (sensor/s) these are located one on the exhaust manifold ( from engine follow exhaust manifold you will come to a things sticking out with some wires on) this is HO2S sensor bank 1, or if you look under the car on the exhaust, just past the catalytic converter you will see the same thing, this is HO2S sensor bank 2, it may be either of these, but i possibly would go for the first one, EVAP..it could be, if you have an air leak on it, the EVAP can be found under the hood/bonnet, at the front on the right hand side as you look into the engine/motor bay just in front of the screen was bottle...hope this helps
Posted on Oct 02, 2010
Tips for a great answer:
Sep 22, 2016 | Mercedes-Benz C-Class Cars & Trucks
Nov 16, 2014 | 2005 Mercedes-Benz C-Class
Mar 22, 2014 | Mercedes-Benz C-Class Cars & Trucks
Dec 11, 2013 | Mercedes-Benz Cars & Trucks
Mar 21, 2012 | Mercedes-Benz C-Class Cars & Trucks
Aug 14, 2011 | Mercedes-Benz C230 Cars & Trucks
Apr 27, 2011 | Mercedes-Benz CL550 Cars & Trucks
Feb 26, 2010 | 2005 Mercedes-Benz C-Class
Apr 10, 2009 | 2003 Mercedes-Benz C-Class
31 people viewed this question
Usually answered in minutes!