Question about 2002 Nissan Sentra

1 Answer

Winshield liquid problem - 2002 Nissan Sentra

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 14,195 Answers

What's it not doing?

Posted on Nov 28, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my new winshield wiper not clear the winshield completely?


Try replacing the arm also. There might not be enough tension in the arm pushing on the blade.

Oct 02, 2014 | Cars & Trucks

1 Answer

Peugeot 607 2004, the winshield wipers do not work (the liquid is not being pumped). Thank you


if you mean the washers then this is a common fault if you put that blue liquid in ,the antifreeze makes the rubber seal inside swell up and jam ,what i do is to remove the pump take it apart and the rub the rubber down so move freely again ,a new motor is around 30 euros

Jul 25, 2013 | 2010 Peugeot 607 2.7

1 Answer

Winshield wipers won't work


have you checked the fuse and relay.

Dec 06, 2012 | 1992 Ford Tempo

1 Answer

Winshield warning light is on in the information center


I have the same jeep it is the washer fluid level. you need washer fluid

Oct 28, 2012 | 1997 Jeep Grand Cherokee

1 Answer

Only have one speed on winshield wipers on a 2001 chevrolet silverado


Generally this has to do with the control board which is mounted under a little cover on the windshield wiper motor.

You can remove that cover (torx screws).. and you will see that circuit board..and the black plug attached to it.

By gently wiggling it..and prying.. you can unplug it for inspection or replacement.

9 times out of ten it's cracked solder joints at right behind that black plug.. you can use a solder iron to simply make them liquid again..eliminating the tiny cracks (cold soldered) I think there are four. Chances are this will fix it.. otherwise..you probably need this module.. referred to as a Wiper Pulse Board.. cost between 20 and 30 dollars.

Best of luck to you!

Apr 22, 2011 | 2001 Chevrolet Silverado 1500

1 Answer

2003 Ford Escape: When I press the button to my rear winshield washer the motor turns on but the fluid actually runs out onto the ground just above the right front tire wheel well on the passenger...


Sometimes due to deposite of sediments in the hose or the joint of hose and reservoir the fluid stops flowing. Find out which is the washer reservoir, (there is one for the radiator with green liquid, and one for the washer with clear liquid) and the hose that leads to the windshield. Clean the whole hose of any blockages. Also check and clean the jet at the end of the hose. take a paper pin and clean the jet with it. And make sure that the hose is attached to the reservoir. Ask someone to run the washer and see where all these items lie.

Dec 13, 2010 | 2003 Ford Escape

1 Answer

Windsheild wipers work only on the low speed


check the winshield wiper fuse sometimes they have a high low wiper fuses otherwise they can be known for the winshield wiper delay switch to go out

Nov 21, 2010 | 1993 Ford F350

1 Answer

99 yukon brake lights will not work, repllaced brake light switch still wont work


Had the same problem on my Yukon, I had to get the winshield wiper switch (controls cruise control, turn signal, and winshield wipers) replaced. This switch controls the hazards as well.

Nov 06, 2010 | 1999 GMC Yukon

1 Answer

Winshield wiper just went out on 99 plymoth


CHECK WIPER FUSE.IF FUSE GOOD POWER GOING TO WIPER MOTOR IF YES.WIPER MOTOR IS BAD. IF NO BAD SWITCH OR BROKE DISCONNECT WIRE.

Feb 24, 2010 | 1999 Plymouth Voyager

1 Answer

Accessive moisture on the inside of vehicle


you dont supply enough info. if it is excess humidity you are probably trying to drive with the heater on reciculate.the humidity is from your breathing this is only to be used when the AC is needed in its coldest funtion. if it is an oily kind of moisture or a sweet tasting liquid in the carpeting toward the heater it is probably from a leaking heater core. if its just water in the carpeting have someone spray water on the winshield and door areas until you locate the source of the leak.

Feb 19, 2010 | 1995 Isuzu Trooper

Not finding what you are looking for?
2002 Nissan Sentra Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...