Question about 1996 Ford Taurus

1 Answer

How do I remove door panels on 2007 Hyundai - 1996 Ford Taurus

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 91 Answers

There are screw along the bottom and edge of the door that need to be removed. Also remove the one at the door latch. There are also 2 that are under little covers in the door handle. Once these are all removed, pull the door panel from the door, being careful to not lose the plastic clips.

Posted on Jan 30, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jammed door on a 2007 Entourage


The door latch is damaged, you need to remove the inside door panel and replace the latch, it is a dealer only part.

Dec 31, 2016 | 2007 Hyundai Entourage

1 Answer

Replace Front Door Handle on 2007 Hyundai Accent Hatchback


remove the door trim and get to it from the inside of the door

Jun 08, 2016 | 2007 Hyundai Accent GS Hatchback

1 Answer

How to replace ignition switch on a hyundai tiburon


Removal & Installation

Specific to:
Hyundai Entourage 2007-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disconnect the negative (-) battery terminal.
  3. Remove the crash pad lower panel (A).

    0996b43f80e41e86.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash pad lower panel (A)
  4. Remove the 2 screws (A) and the trip switch connector.
  5. Remove the crash fascia panel (B).

    0996b43f80e41e87.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash fascia panel (B)
  6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
  7. Remove the ignition switch (A).
  8. Installation is the reverse of removal procedure.

    0996b43f80e41e88.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the ignition switch (A)
Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
  3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

Aug 02, 2014 | 2006 Hyundai Tiburon

1 Answer

2007 Hyundai Accent the driver side door won't open from the inside. It opens from the outside so I have to roll down the window and open the door before i shut the engine off.


Either the interior door handle or the cable inside the door is broken. You'll need to remove the door panel and look to see what is damaged.

May 25, 2011 | Hyundai Accent Cars & Trucks

1 Answer

How do I remove the door light


remove the inner door panel

Aug 12, 2010 | 2007 Hyundai Tiburon

1 Answer

How to take off the door panels off a 2008 hyundai tiburon


after removing the screws in the grab handle slide the trim ring for the door pull forwards,check for any other screws facing you in the panel,then with a wide bladed driver starting from the bottom front corner pull away the trim panel,an inch at a time,YOU WILL break some of the clips and will need to get new ones.make sure you glue/tape polythene sheet back on or you will get water leaks.....

Jun 18, 2010 | 2007 Hyundai Tiburon

1 Answer

How do i install the outside drivers door handle on 2007 hyundai


you have to take the inside panel off the door, and you will see the steps on how to do it.
Once you take that inside panel off you will see it step by step and as you take the old one off remember how you did it to put the new one on
I hope this helps

May 28, 2010 | 2007 Hyundai Sonata Limited Sedan

1 Answer

Hyundai tucson 2007 rear door wont open, alarm switch, power switch and key will open all doors except rear.


Sounds like the acutator that pushes and pulls. either lost power or died. I would assumed died. U need to check to see if it is on a seperate fuse first, it may be. If the fuse is ok, remove the hatch inside plastic panel and arm and disarm the alarm. See if the actuator moves.

Dec 08, 2009 | 2005 Hyundai Tucson

2 Answers

Need instructions to replace 2007 Santa Fe side view mirrors


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Mar 18, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Passenger automatic lock


Hi There,
You'll have to remove the door panel....Once it's off you can determine where it's getting stuck, which may be on the door panel, then you can rectify the problem.

Regards Johngee10

Sep 06, 2008 | 2007 Hyundai Sonata Limited Sedan

Not finding what you are looking for?
1996 Ford Taurus Logo

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...