Question about 2005 Toyota Corolla

Open Question

Corolla hatchback 2005 tt3 video on replacing headlight bulb

Passenger side near battery

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: Headlights

I READ ONLINE THAT THERE WAS A RECALL ON THIS YEAR AND MAKE, CHECK WITH TOYOTA WEB SITES TO RECTIFY YOUR PROBLEM

Posted on Jul 25, 2008

Ad
johnthejag
  • 286 Answers

SOURCE: Headlight bulb is out on...I need to replace it.

Put on your marigold gloves, pull off the 3 terminal plug behind the bulb.
Undo the retaining ring.
Pull out the bulb, memorizing its position, check its the same as your new one, and don´t touch glass on new bulb, as any grease on it will do it no good.
Pop it in and fit the securing ring and refit the plug.
Now test it for dip and main beam.
See it was easy !
Good Luck !
John.

Posted on Jan 13, 2009

  • 49 Answers

SOURCE: headlight problem

need to change the turn signal the power for the headlight lows is going thought that switch

Posted on Feb 05, 2009

ourhowse
  • 2007 Answers

SOURCE: How do you change the headlight bulb (low beam) on

You should be able to access the buld holder from the rear of the headlight. It's a nylon bulb holder with a lock thing on it. You squeeze the lock part and turn it counterclock wise, and it should come out. Remove the old bulb and install the new one being careful not to touch the glass of the new bulb with bare fingers. The finger print you will leave can cause the bulb to prematurely die on you.

Posted on Jun 15, 2009

  • 1986 Answers

SOURCE: How do I replace headlight bulb for my toyota corolla 1998?

Open up the hood, and go in behind the fixture where the light is located. Grasp the headlamp electrical connector socket (with wires coming out of it) and disconnect it by pulling straight back. Pull off the black, soft rubber protective housing that surrounds the back of the headlamp housing. You will then see a spring clip securing the bulb. Push the clip in and up on an angle and it will release the bulb. Never touch the new bulb with your bare fingers, as the skin-oil you leave will greatly shorten the bulb's life. Place the new bulb assembly into the housing, push the clip in and up again, but in the opposite direction of the first angle to release it and it will lock. Then replace the black rubber housing-cover, plug the electrical connector back in, and you're in business.

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Lexus RX330 HID ballast replacement, passenger side headlight. What is the removal procedure please?


I have a 2005 Lexus Rx330 with HID AFS headlight. My passenger side light went out. I thought the bulb burnt out, so I bought a new bulb. After replacing the new bulb, it happened exactly like my old bulb. It light up lightly and then total black out. What's wrong with it? I thought the ballast burnt. I called Lexus dealer and asked for the new ballast/transformer. Surprised me, they don't know what is it. They told me they only know the wiring harness and the socket, but not the ballast ??????? Could you tell me what do I need to replace?

Thanks,

Feb 02, 2010 | 2005 Lexus RX330

1 Answer

Is the low beam headlight bulb difficult to replace from under the hood on a2005 honda accord


I just replaced both low beam headlight bulbs on my 2005 Honda Accord. After reading the owner's manual and trying to remove the wheel well inserts (and breaking a couple of those clips in the process), I gave up on that approach and was able to change the passenger side and driver side low beam bulbs from the engine compartment under the hood. On the passenger side, fit your arm between the front of the car and the hose that is above the headlight. You should be able to reach the bulb, disconnect the electrical connection, turn the bulb 45 degrees counterclockwise to remove it, insert the new bulb turning it 45 degrees clockwise to secure it in the hole (be careful not to touch the bulb), and reconnect the electrical connection. I loosened the 3 screws that secure the bulb to make it easier to put in the new one, but that probably isn't necessary. My hand was scraped a bit doing this, but it was not too bad. On the driver side, remove the battery hold-down clamp (there is no need to disconnect the battery connections). Reach into the fender (shine a light there so you can see the bulb connection) and you should be able to reach the bulb and replace it similarly to the other bulb. You may have to move the battery slightly to get your arm in there. Replace the battery hold down clamp when you're done. I accidentally dropped the old bulb in the wheel well, but other than that it went pretty smoothly. Good luck.

Jan 03, 2010 | 2005 Honda Accord

1 Answer

Howdo I replace the headlight son a 1998 corolla?


the bulb is held in with a metal clip, if your trying to replace the driver side, check out the passenger side first, it will give you a idea of what your working with

Dec 04, 2009 | 1998 Toyota Corolla

1 Answer

2005 Jeep Liberty Sport. Headlights. Passenger Side is dim


TEST
remove both bulbs from the lamps but leave them on their wires switch on and see if the bulbs are still different brightness if not they the passenger side lamp housing has damaged mirror is dirty or missalined and needs adjustment. if they are different brightness then this may be a earthing problem.


Nov 13, 2009 | 2005 Jeep Grand Cherokee

2 Answers

Audi TT Intermittent headlight


Did exactly as you said, replaced both bulbs with the d2s as you said and got them on ebay, driver side was clearly more difficult to put in, passenger side very easy, worked perfect for 1 day and the intermittent problem returned. What to do.

Aug 22, 2009 | 2005 Audi TT

1 Answer

Replacing headlight


all you have to do is flip the wire keeper to pop out the bulb from the back of the headlight assembly

Apr 30, 2009 | 2005 Toyota Corolla

1 Answer

Audi TT HID bulb needs replacing


You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.

1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.

2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.

3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.

4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.

5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.

6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.

Good luck.

Mar 14, 2009 | 2005 Audi TT

2 Answers

Headlight problem hatchback, replace highlight bulb drivers side


Hi. You may wanna remove some additional accesories that may obstruct your way to the light bulb. usually these are locaated in front of the battery, so you need to disconnect and remove it and change the bulb.

Jul 07, 2008 | 2002 Toyota Corolla

Not finding what you are looking for?
2005 Toyota Corolla Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...